Jim, I fail to see your logic in issuing a random serial number on the premise that a station is expecting a higher serial number than "1". How on earth is the other station to know you are in casual
Darrel, This one's in the help file. You are using %3 which is numbers in full. %N3 is for cut numbers. Make sure you have done the necessary to your .ini file of course. 73 Dez - ZC4DW -- Original M
Wayne, Alt-K will let you transmit direct from the keyboard to send a little message. It's on a toggle, so Alt-K will close the window afterwards. 73 Dez - ZC4DW -- Original Message -- From: "Wayne A
Hi Mike, You might care to experiment with the display settings of your monitor. I find my Compaq 17" monitor is quieter (around the ham bands at least) running at 800 x 600 pixels, rather than say 1
Same here! Have never suffered any of the reported problems with Writelog & MMTTY 1.63 Mine's an old clunker Pentium 200 MHz, however I only use MMTTY on RX with a 10 buck soundcard. I generate the F
Dash, Try the Help menu under, "CW and RTTY and Voice Memory Setup". QUOTE: "the letter "N" optionally followed by a digit n the serial number is sent, padded with leading zeros if necessary to get t
Hello Gil, I think the bandwidth is fine, 3 KHz (or more!) is way too much. For me, the spectrum display wins every time. I only want to see one signal at any one time. Just give me Mark & Space tone
as Hello Rob, You will need to add something like this to your writelog.ini file if you wish to use %N3 in your CW exchanges: [Cut-Numbers] 0=T 1=1 2=2 3=3 4=4 5=5 6=6 7=7 8=8 9=N You should find tha
Gil et al, Apologies in advance, not specifially Writelog related. I'd wager most of the serious RTTY ops actucally run FSK and not AFSK. Would be interesting to take a straw poll, but not on this re
Hi All, Recently I upgraded my motherboard, but wanted to retain my existing hard-drive. The H/Drive had a fully functioning version of Writelog, which I am subscribed to, (10.31). However upon runni
Hello Again, I posted the original message 24 hours ago, but for some reason my mail has only just appeared on the reflector. I have since succesfully installed Writelog again. The problem was, the u
Hi Guys, Just tried the SCC contest module, and the problem is solved if you move your cursor out of the CALL field. Try pressing the + key now. That should log the QSO, and not diddle. 73 Dez - ZC4D
Hi, For RTTY contesting the RST which I usually send is 599. A typical buffer I might use could look something like this: %R%C UR 599 %3 de ZC4DW BK %E Which will send (on a new line): His Callsign U
Hi All, Been using a KAM and a KAM+ since the year dot (well almost), with various software, and Writelog 10.xx exclusively for the past 12 months without any problems. I have never experienced misse
I would not be so fast to retire the KAM! I also run MMTTY in parallel with the KAM, and whilst MMTTY does decode the weaker signals better than the KAM, the Kantronics All Mode decodes those station
Hi All, I've just downloaded the updated WL_CTY.DAT file, but can't seem to find = the "Convert cty to WriteLog" program from the WriteLog program folder. Can anyone give me a clue what the filename
Just a reminder that the RSGB JUBILEE contest takes place this coming weekend. There is a WRITELOG module available for download from the following site: http://www.rsgbhfcc.org/ Follow the links to