That was indeed my problem. Sure enough, Comm PTT was set to 'RTS' instead of 'No' in the Setup/Ports window for the second K3 receiver. PTT didn't release only on my sub-receiver Rttyrite window and
Eric, I'm still not sure if you've fully checked what Joe and I are referencing. Please go to the Setup/Ports window and in the upper right corner you will see a column heading 'Comm PTT'. Each of th
1. In the [Configuration] section of your writelog.ini file what is the number in line: SendCallExchangeKey=5? 2. What is the message in Fn, where n is the number in 1. above? Ed W0YK -- I have enter
The following comment doesn't directly address your concern, but it describes how I avoid this issue. I save each contest in its own folder along with any other files pertaining to that contest, like
Good work-around though not quick for mode-changing. Remember, though, that WriteLog is a contest logger. DXpedition and general logging are not as fully-featured in a contest logger. This is the sam
The requirement of using a mouse/trackball to click buttons in additional windows on the screen is a non-starter for me. For others, though, this UI may be fine. The last software update was 14 Febru
Yes, and I used WriteLog for W1AW/6 just fine. High rates and all. But, I was not changing modes so often that I needed a fancier way of loading messages than what has been suggested. Gary AL9A outli
I've never used these functions before, but just tried them in 11.24d (Beta) and they don't work there either. Do you know what WriteLog version they did work for you? Ed W0YK -- I'm trying to get Ba
I use ESM, so the Plus accelerator key is executed when I press Enter at the end of the QSO. The other alternative is to define another key on your keyboard to be the Plus key. Go to Setup/Keyboard S
Wow, that's a long time ago! If we're right about these two commands not working any more, then Wayne will have to look into it, I guess. I use a lot of the other commands and haven't run into any th
Read the RTTY Contesting column in the Jan/Feb 2015 issue of the NCJ and see if that answers your question(s). Ed W0YK __________________________________________________________ I have only seen a co
Perhaps some comments will be helpful to both you and the list. First and foremost, carefully read and follow the microHam application note for WriteLog available on the Router's Help or Support menu
There are several different ways to use and manage a call sign stack. Some are easier to setup but take more keystrokes to operate while others have more involved setup with the benefit of more effic
'NL' is used in some contests as a single multiplier that combines Newfoundland (VO1 or NF) and Labrador (VO2 or LB) into one contest multiplier. In Round-Up, NF and LB are separate multipliers (see
I fell for that, too. It's the old zero vs. letter-O issue. ;>) Ed W0YK ____________________________________________________________ It is a valid callsign - http://www.qrz.com/db/VO1VR/?mlab= Jerry
I create and use my own prefill databases. I agree with Randy's post below. I also agree with Gary's comments. How can this be? Randy advocates that we strive to become better operators by copying ex
Do you feel the same way about Super Check Partial? Ed W0YK _________________________________________________ Hans K0HB wrote: On the other hand, if the prefill material was harvested from hundreds o
How many of the "SO2R guys" who "push you down in the standings" are operating from a "small city lot . 1 trapped beam, 1 homebrew short 160m vert. and a very low 80m inv. V"? Most SO2R operators hav
In radiosport, the term "Assisted" (or "Unlimited") is defined by the contest sponsor. Ed W0YK _____________________________________________________ My definition of "assistance" is fairly narrow.
There is a very good reason to request different registration codes. The problem with only changing CALLPREFIX in writelog.ini (as compared to getting a new registration key), is that in Rttyrite, yo