Jim, I have also experienced various polling problems with my Kenwood Ts-950sdx and Writelog, without a solution. I also have a Kenwood TS850 and two different IF-232 interfaces, two computers, and I
I have had a long time problem with rig polling with my Kenwood TS950SDX and Writelog. I would appreciate hearing from anyone that might be using this radio with Writelog, and exchanging information
I noticed this too, and asked about it a few weeks ago with no reply. It also tied into the question of opening a separate band map for each band, with the hope that the packet spots would fill up ea
I am sure this has been asked before, but, how do I fill the band map window, when I change bands, and the packet spot windows if full of mults? Seems there is a way to force this, I think, but I can
I attended a club meeting yesterday where the presenter was talking about RTTY contesting using Writelog. He said that there was a way to use Writelog such that the 2nd radio (SO2R) could be set to a
I attended a club meeting yesterday where the presenter was talking about RTTY contesting using Writelog. He said that there was a way to use Writelog such that the 2nd radio (SO2R) could be set to a
I am setting up a laptop with Writelog 10.18 for a DX Pedition I am going on. I am an experienced Writelog user, but ran into a problem. No matter what I do, I can't seem to get the various windows t
I am going on a dxpedition, and want to use WL for logging. I will be operating on all modes, SSB, CW, RTTY, and PSK, but I don't see where / how to log the PSK mode qsos. I have selected the general
I cannot seem to figure out how to log the PSK mode in Writelog. The only options I see are for CW, SSB, and RTTY. (I am not asking about how to work PSK, I know that. I am asking about logging the M
I have a new setup of Writelog 10.19. In my rtty window, it does not stay up or visible when I click into the qso entry window, so every time I do that, I have to go back to the task bar and open it.
Mike: Windows 98 supports dual monitors out of the "box". All that you need is a second video card and monitor, and Windows 98 will recognize it and configure itself. I am using Writelog with this co
Mark: I have the exact same polling problem with my 950sdx. Rig control works perfectly with other windows logging and rig control software w my 950sdx, but with Writelog, it is definately a problem.
I have been a long time Writelog user, using the software with both a Kenwood TS-950sdx and Kenwood TS-850. I also use Top Ten Devices to automatically change antennas when I change bands, etc. For q
Guys: Am I trying to get 10.49 set up for RTTY for the contest, using a KAM plus set up for FSK. Every thing seems to be working ok, except: In the RTTYrite window, I cannot seem to be able to click
When I have the cursor in the Call Window, and I then go over to the rttyrite window to click on a highlighted callsign, the cursor moves into the rttyrite window. I am not sure what you are suggesti