I'm taking a stab here, but I'd figure the file is at least a couple of orders of magnitude bigger. Not what I want bogging down my PC in the middle of a 100+ hour, for sure. Blake N4GI
Writelog automatically routes audio between R and L channels. So does my DXDoubler. I don't need to have soundcard AND the DXD routing audio for me. Before I go hunting a Y adaptor for my one channel
Maybe I'm missing something: Exactly how does one listen to a sidetone coming from the PC, with headphones on, in the middle of a contest (during a 150 hour run, say)? Also, if Writelog is generatin
Use the < or > before or after the message part. It's in the help file in the setup CW messages box. Personally, I can't stand copying the speeding up and slowing down exchanges, it's a real rythym b
Having not found any historical data; I currently have WL on one PC running 2 rigs on Com1 and Com2 (1xIcom, 1xYaesu). I have only one LPT port now. Which rig's band data comes out of that LPT port?
The only resources you need to make this happen are a hot soldering iron and a 1/4 inch stereo plug. Neither CT nor Writelog cannot stop your bencher. Blake N4GI
In 30 seconds, I typed: <icom 706 rig control> into Google and got this <http://www.k6xx.com/radio/tr706cbl.html> ...along with about 10,000 other hits. The W1GEE cable works well too (not affiliate
Here's an excerpt from my .ini file. K9JY's site instructions seem simple enough, however I don't see the spot to put the ComSlotX=X "alias" to change my Com5 into Com3 for rig#2 control purposes. Do
Yep. I spelled -Com- wrong. It should have two M's -Comm Hopefully we can all get past that, because I still don't know where to put the command in the .ini file. Thanks Blake n4gi change
-- Original Message -- an I just finished mine up Scott. Interfaces with WL as a DCU1 perfectly! One gizmo that no HamX rotor owner should should do without, IMO. not affiliated, of courseBlake N4GI
I don't understand the point of this thread, nor how any of the problems is the fault of WL: 3 super easy steps: 1- Submit the right log format for the contest, to the right address (see XX contest r
I wouldn't normally post a question here, as I usually find answers by myself, however I am out of options, and have never read a post addressing my problem in any past posts: When I set up new conte
ini I went through this recently, here was the answer I got, tnx W6IHG. Just put the line in there, works like a charm: <<<Put it right after all the comm rates in the [Ports] section CommSlotX=X an