The "SpecialBackgroundColor" is currently only used in one case: the EU DX RTTY contest module scans for incoming lines that look like received QTCs. When it spots them, it highlights them in this co
the writelog instructions describe ivetBUI only because it is easier to install. TCP/IP works too. Wayne --Original Message-- From: "Petr Spacil"<p.spacil@ctipro.cz> Sent: 2002-02-27 17:11:27 To: "'W
I have put an update to the WL Stew Perry module on the WriteLog web site. I have tested it to the extent of sending a bogus check log to the tdbc email robot, which seemed to parse it correctly. If
I haven't tried this myself, but here is a posting made several months ago on this reflector: http://lists.contesting.com/_writelog/2001-October/007188.html Wayne
WL version 10.28 and earlier drive pins 1 and 17 on the LPT port with the CW signal. Pin 1 goes low for key down, and pin 17 goes high for key down. Version 10.29 changed to hold pin 1 low all the ti
The direct-io folks have posted instructions for how to use their product with WriteLog. Please use this support info: http://www.direct-io.com/kb/q600003.htm Wayne, W5XD
Try this in WRITELOG.INI (Click the Windows Start menu, click Run, type in WRITELOG.INI) Find the [PORTS] section. Add this line: CW_ON_PIN1=1 Do File Exit. Save it. Run WL again. (Works only in vers
There is a program in WriteLog's \programs folder called FPORT16.EXE that is probably causing the problem. It reads the BIOS for the LPT port address assignments and sets the entries in WRITELOG.INI.
The entry window limits its selections to mono-spaced fonts. "Mono-spaced" means all characters in the font take up the same width. Why the mono-spaced limit? because thats the way the software was
I risk throwing gasoline on a fire, but I'll take that risk hoping I can offer some suggestions that will help the discussion on this thread. I don't like the negative tone of many recent posts here
The downloads page (http://www.writelog.com/downloads.htm) has a comment for each WLxxxxUPG.ZIP naming the oldest version it can upgrade. The 10.29 upgrade can go back as far as 10.22. In addion, eve
This is a multi-part message in MIME format. --=_NextPart_000_000B_01C18B0E.C93DAD30 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit in case anyone would really like to k
This is a multi-part message in MIME format. --=_NextPart_000_0009_01C1908B.DED92070 Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: 7bit Take a look at this October posting
Several people have reported problems with LPT port CW in version 10.29E. All of these so far have been tracked down to hardware setups that require the "old" behavior on LPT port pin #1. We don't no
you might try setting the INI file entry to something really big: [RTTYRITE] ScrollBufferLength=1000000 Then the Rttyrite window will keep the entire contest in its scroll buffer. You can do an Edit
This error is almost always the result of a file marked ReadOnly that the WL installer wants to replace. Read the rest of the message--it names the file in question. Browse to the file with File Mana
I think this is a problem with the WL installer. The installers for 10.23 and later can only successfully upgrade a 10.22. So if you upgraded from something older than 10.22, you need to install 10.2