Robert, you're no wally - that's how it works. Jerry gave one work-around, but the best is just not to worry about duplicate serial numbers! IT DOESN'T MATTER. This has been discussed before, and I
I don't know if my article would help you - http://www.qsl.net/wa9als/so2r-mmttyx2.htm Also these will separate which card WL uses for contesting vs playback/audioreview: [Configuration] SoundBoardIn
card I was looking at cables at RS and noticed an interesting one. 1/8 inch mono plug on each end. It was labeled something like "attenuator" cable for mic inputs. Must be some sort of extra-resisti
OK, wearing my ignorance on my sleeve agn - I don't see where to put precedence in cabrillo log. Power choices are HIGH, LOW, and QRP. Do I just edit power to "U" after making the cabrillo?
I couldn't get any of several different optos to key my FT-1000MP, but a simple transistor interface works fine. 1K resistor in line with RTS to base of 2N2222 or 2N3904 with DB9 ground to emitter.
For CW and SSB, using an IC-756PROII, my transmitted signals were recorded without any special settings of WL. It must depend on whether monitor audio/sidetone is on the audio out line supplied to W
OK, here's a "no answer answer". I use v10.33C. I just copied your F11 message into my SSCW F11 buffer, and it works perfectly. Anyone else using the same version as Dick (v10.36G)? GL - 73
connection, then if an open produces versa. to collector that and I suppose it's all PFM I built my first interface from the instructions provided with K6STI's RITTY program. Brian described the bas
log, 1. What happens when you try to import from the smaller log into the larger? 2. Both contests support Cabrillo - Seems like if there aren't too many Qs, you could just cut and paste from one Ca
given this problem. I expect several will chime in to defend WL in a networked environment. My experience is limited to 2 CQWWRTTY contests with 2 networked computers. Computer A is recent with WIN2
I am trying to get WL 10.36 to work with MMTTY, ver 1.61. I followed the steps on AA5AU's page, including loading the plug-in. I can receive OK, but I cannot transmit. My standalone version of MMTTY
first That That's all essentially correct. If you're using DX Telent, you will see the DXTelnet <>WriteLog Spot Linker window, and no other window will appear when you chose Window|Packet from the W
Some will appreciate this broadband off-topic and some won't. I'll take my chances. There are several new viruses going around big time today, some apparently via ham reflectors. I got several -appar
I think it shows in the Networked Frequencies window, under R MODE. We noticed an R next to the running station and wondered how WL knew that. Based on the use of F11? Based on seeing a bunch of Qs o
the 1. This already exists. Just enter %B in one of the macro slots. Then enter the desired callsign in the ENTRY area and hit the macro key. However, typing the callsign and hitting the key to put