That can't quite be it either though. I tried a 10-hr NAQP contest - 272 Qs. The program said 5/hr... That's not even close if you considered the whole 12 hr allowed period. I think the RATE program
for checked *You need %E at the end.* Your question was appropriate for the WL reflector, but you didn't need to post to the RTTY reflector, FYI. GL - 73
in motherboard the I can't argue with any of that. However, ISA is going, going.... and with it goes RITTY. If someone is buying NEW, I would advise the Soundblaster 16 PCI for $30 and its use with
The good news is that your 1 computer can easily DO IT ALL! Your question is a little confusing, but here's a try. Please clarify a bit if you don't quite get the answer you're looking for. 1. You on
Dave you could've saved yourself a lot of headaches by getting a transistor and a couple of resistors from RS instead of using the Rigblaster. I think it's only really meant for AFSK, isn't it? With
It's your lucky day! If you smile real nice and promise to be nice to someone on the ham reflectors today, I could put the following in the mail to you: 1. 1 new 4-pin DIN for the Yaesu 2. 1 cable w
I complained quite a bit a few years ago about the Byterunner 8-port PCI card. It wouldn't install. The service tech sent me the very latest drivers, and after about 5-10 minutes on the phone with hi
The entry to change the com port number is CommSlot4=6 The rest of it belongs on another line, e.g. COM6=9600,n,8,1,x Should look like: CommSlot4=6 COM6=9600,n,8,1,x although all the CommSlot entrie
What's the matter with you guys? You obviously haven't used WriteLog or otherwise been around very long. Disk? What's that? I've never had WL on a disk - Guess I've missed something. The manual IS on
I have one. The drivers are available from the web site http://www.matrox.com/mga/support/drivers/certified/home.cfm. I have the driver package 5.72.021 from this page for WIN2000. It is a self-insta
This is a common question, and the answer is easy - and WriteLog does support higher com ports. It does only support 4 ports AT ONE TIME, but they can be higher numbers than 1-4. In the ini file, yo
OK, it was appropriately pointed out to me that the originator of the question had the following needs: "2 radios, rotator and packet = 4 COM ports, none left for CW keying!" To which I respond, can'
Try again. I just did it (8 sec download via satellite!). Installed flawlessly. Then click Help | About, and it shows v10.33C - same on the first window that comes up. Be sure you run Setup.exe and