Author: Eric Rosenberg <ericrosenberg.dc@gmail.com>
Date: Fri, 26 Nov 2010 20:03:39 -0500
Setup: I'm using the DB-37-EL-K3R cable from the MicroKeyer2 to the rear of the K3. 1- The CW decoder only works if WL's CW Decoder is set for Stereo (2 radios) and displays to decoder screens, one b
It depends on which CW decoder you are using. If you want only one decoder, set Writelog for a "sound board" instead of "stereo sound board" or right click on the CW display, select "setup CW decode
Author: Eric Rosenberg <ericrosenberg.dc@gmail.com>
Date: Mon, 29 Nov 2010 20:45:10 -0500
Correct on #1, not #2 As I said, Mono does not work. Looking at the display, one can see that no audio is being fed from the radio to the 'correct" channel in WL. Stereo does work, as audio is being
No, the problem is in WriteLog. If you are using the default sound card, the Stereo/Mono switching operates correctly. If microHAM CODEC is not the default sound card (the preferred configuration fo
Author: Eric Rosenberg <ericrosenberg.dc@gmail.com>
Date: Mon, 29 Nov 2010 22:36:06 -0500
Joe -- Thanks for the explanation. Here's the existing setup: The MicroHAM USB Device Router 7.7.1's AUDIO MIXER is now set this way: MicroHAM CODEC (options are None and Intel(r) Integrated Audio (t
Eric, There is nothing that you can reconfigure in either microKEYER or microHAM Router. You need to make microHAM CODEC the "default" audio recording device in the Windows Audio Control Panel. That