- 1. [Yaesu] DC power supply connector (score: 1)
- Author: Claude Frantz <Claude.Frantz@bayern-mail.de>
- Date: Tue, 24 Jun 2014 12:18:14 +0200
- Hello (X)YLs and OMs ! I'm still trying to determine the model number and manufacturer of the 4 pin DC power supply connector which is used on the FT2000. If I'm informed well, the same connector is
- /archives//html/Yaesu/2014-06/msg00002.html (6,632 bytes)
- 2. [Yaesu] FT-2000 in transverter mode (score: 1)
- Author: Claude Frantz <Claude.Frantz@bayern-mail.de>
- Date: Thu, 14 Jan 2016 08:13:54 +0100
- Hi dear community, is the low level transverter output limited to the amateur frequency band limits, in the same manner as the main output ? Thanks a lot ! Best 88 de Claude _________________________
- /archives//html/Yaesu/2016-01/msg00001.html (6,492 bytes)
- 3. Re: [Yaesu] Yaesus using RF speech compression (score: 1)
- Author: Claude Frantz <Claude.Frantz@bayern-mail.de>
- Date: Sun, 4 Jun 2017 18:13:10 +0200
- Is DSP based compression used on any model ? Best wishes, Claude _______________________________________________ Yaesu mailing list Yaesu@contesting.com http://lists.contesting.com/mailman/listinfo/y
- /archives//html/Yaesu/2017-06/msg00002.html (7,063 bytes)
- 4. Re: [Yaesu] FT1000MP overheating and audio failure (score: 1)
- Author: Claude Frantz <Claude.Frantz@bayern-mail.de>
- Date: Tue, 29 May 2018 07:37:39 +0200
- Hi Bob, If the SWR indicator of your XCVR says that the SWR is infinite (in the case of a load which is probably nearly 50 , as you said), then I see mainly two possible reasons: The path between the
- /archives//html/Yaesu/2018-05/msg00008.html (8,574 bytes)
- 5. [Yaesu] FT-2000: Low level TX signal output especially for transverter (score: 1)
- Author: Claude Frantz <Claude.Frantz@bayern-mail.de>
- Date: Fri, 2 Apr 2021 16:54:23 +0200
- Hi all, According to the text on the page 32 of the operating manual, the "TRV Jack", on the rear panel, provides a -10 dBm TX signal, especially for a transverter. In which frequency range is this s
- /archives//html/Yaesu/2021-04/msg00000.html (6,709 bytes)
- 6. [Yaesu] FT-2000 CAT commands (score: 1)
- Author: Claude Frantz <Claude.Frantz@bayern-mail.de>
- Date: Tue, 18 May 2021 17:34:28 +0200
- Hi ! When sending "TX;", what is the response "TX3;" which I cannot find in the CAT operation reference book ? Thanks to you ! Best wishes, Claude (DJ0OT) ____________________________________________
- /archives//html/Yaesu/2021-05/msg00000.html (6,004 bytes)
This search system is powered by
Namazu