I would swear that I have seen in one of these elists, plans for tilting a Rohn 25 tower. The idea is to free stand 45 - 50' of tower or whatever will tolerate up to 80mph of South Plains dust storms
is it really called a Spectral Analyzer? is it sold by GhostBusters, Inc? iow, SpectrUM Analyzer makes sense, the other does not. but then, considering the decline in proper English usage, nothing sh
no room for jokes on this list I guess... sorry you are having an off day. btw, 90+% of the English speakers/users of the internet are AMERICAN English users. albeit they are more illiterate and less
Steve I use a Cobra Sr ultralight <http://www.k1jek.com/> which is 50' agl at one end and 35'agl at the other end fed with 100' of ladderline thru a 9:1 balun into a Dentron 3000A tuner via coax. Han
Mark if you think about it and visualize it... what is best is getting the anchors (fill those pipes with concrete!!) out as far as possible to assure as low angle as possible. As stated, Not Less th
Jim, don't you reckon that if you had to sacrifice one vs the other that the support every 120* on the compass is probably more important than the distance out from the base to the support pipes? as
Here in Houston (where summer lasts from Mar thru Dec) wasps are always active. I am not about to let them have 10 months of reprieve. Anyway, the only bugs I go after are those which act like africa
--Original Message-- From: towertalk-bounces@contesting.com [mailto:towertalk-bounces@contesting.com] On Behalf Of Mac English Sent: Friday, September 17, 2010 10:02 AM To: towertalk@contesting.com S
I want to mount an SGC-239 tuner on the tower below a vertical. but I need a UV proof, sealed, water tight container that I can put the tuner inside - and then put that tuner in a tupperware? into an
Eddy... ok, can you say that again? my understanding is that he is taking a 10' section of 45 and putting 5' of that into a hole and then filling it with concrete. Same thing I did with a 25G. Btw, I
AMEN! My 55' tilt, crank is still on a pallet in the backyard after 4 yrs and really needs to get recabled but mostly, it needs an electric winch which will pull it up but will also clutch it down ki
Zirk fittings come in a thousand dimensions with some of them being self tapping for sheet metal. it is a matter of finding a chart with dimensional information, isfa diam of body, thread type, threa
John, what did you end up doing isfa grounding your Solar Panel rails??? Personally, I would have pulled an 8ga from each roof corner down the side of the house to a point about 3' above g.l. and the
I am looking for an inexpensive rotator to swing my new Pixel Technologies Magnetic Loop. Any Suggestions? 2. Also, wanting to hook this up to my Pro3/KPA500/Kessler AT-Auto. any suggestions on this