Yaesu makes a shock mount for their rotors. If you don't have a Yaesu rotor, maybe it could be adapted. http://www.yaesu.com/indexVS.cfm?cmd=DisplayProducts&ProdCatID=104&encProdID=E0526A9F285ECCF36F
Click on the bottom link. It's the same place you subscribed. You'll need your password. 73, Mike NF4L _______________________________________________ _______________________________________________
Eric - I had one repaired years ago by a guy whose call or name I can't remember, but I think he was listed on the Idiom site. I don't see him listed now. If you do go the replacement box route, anot
Make it easy to disconnect the coax before it enters the attic. If you have multiple antennae, put a remote switch outside and have only 1 coax thru the attic, or at most three if you operate HF,UHF,
Well yes. Mike NF4L _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman
I have no experience with this, but this might work. http://www.uship.com And your tower might be on TV. 73, Mike NF4L _______________________________________________ ________________________________
So THAT"S what my neighbors fences are made of ........=-O 73, Mike NF4L David Robbins K1TTT e-mail: mailto:k1ttt@arrl.net web: http://wiki.k1ttt.net AR-Cluster node: 145.69MHz or telnet://k1ttt.net
Before bluing was invented, gun parts were "browned". That was an induced rusting, which was then rubbed with a mild abrasive( today 0000 steel wool) and oiled. It inhibited further destructive rusti
I'm planning on using Buryflex coax to wind common mode chokes using type 31 ferrites for my 80/160M slopers. I'll be able to get 5 turns thru 2 stacks of 4 each ferrites. A sort of oval roll of coax
On 10/6/12 10:01 PM, K8RI wrote: On 10/6/2012 8:07 PM, Mike wrote: I'm planning on using Buryflex coax to wind common mode chokes using type 31 ferrites for my 80/160M slopers. I'll be able to get 5
Take a careful look at the control box end of the cable for a pin that's not fully seated. Mine has one pin that occasionally gets pushed back far enough to not make contact. 73, Mike NF4L In July I
On 10/21/12 10:51 PM, K8RI wrote: On 10/21/2012 6:09 PM, Jim Brown wrote: On 10/20/2012 7:23 PM, K8RI wrote: My question is about the difference between the 6 cores stacked or two stacks side by side
Wouldn't that be 20 cubic feet, or one long surface would be 20 square feet? 73, Mike NF4L _______________________________________________ _______________________________________________ TowerTalk ma
Here's an intriguing idea. It's for 160, but there's a section on getting it on 80. http://www.w0uce.net/K2AVantennas.html 73, Mike NF4L _______________________________________________ ______________
Please do yourselves a favor and look at Davis BuryFlex. http://www.davisrf.com/buryflex.php 73, Mike NF4L _______________________________________________ ____________________________________________
Fewer connectors comes to mind. What's the drawback to all flex? Mike NF4L _______________________________________________ _______________________________________________ TowerTalk mailing list Tower
Any of these suitable? http://www.dxengineering.com/search/department/clamps-and-fasteners/part-type/saddle-clamps/product-line/dx-engineering-saddle-clamps?autoview=SKU 73, Mike NF4L _______________