Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Amps\]\s+220V\s+service\s+for\s+amplifier\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Amps\]\s+220V\s+service\s+for\s+amplifier\s*$/: 27 ]

Total 27 documents matching your query.

21. RE: [Amps] 220V service for amplifier (score: 1): Author: Joe Isabella <n3ji@yahoo.com>; Date: Fri, 5 Dec 2003 03:38:42 -0800 (PST); Sure, but I notice that the tuning is quite different and I don't tear up my security system, garage door opener, or phones as bad with the amp grounded. I also don't get RF into my audio gear with e; /archives//html/Amps/2003-12/msg00063.html (8,954 bytes)
22. Re: [Amps] 220V service for amplifier (score: 1): Author: R.Measures <r@somis.org>; Date: Fri, 5 Dec 2003 01:43:08 -0800; ** amen ** Heath managed to use a 120Vac fan on the ancient SB-220 by connecting it across one of the dual 120v privaries on the HV transformer. ** One has a choice, unless one enjoys battling compu; /archives//html/Amps/2003-12/msg00066.html (10,437 bytes)
23. Re: [Amps] 220V service for amplifier (score: 1): Author: R.Measures <r@somis.org>; Date: Fri, 5 Dec 2003 01:43:07 -0800; ** Ian -- The neutral wire between the electric-mains' box and my radio room is #6 gauge. At least in my experiences, severing #6 isn't even close to being easy - - and besides that, the drainage is; /archives//html/Amps/2003-12/msg00067.html (8,788 bytes)
24. RE: [Amps] 220V service for amplifier (score: 1): Author: R.Measures <r@somis.org>; Date: Fri, 5 Dec 2003 01:43:09 -0800; ** I conducted a number of signal strength measurements on 40m using a balanced antenna, and no difference was observed on Tx (at the Rx end) or Rx at this end with or without the good RF ground. Al; /archives//html/Amps/2003-12/msg00068.html (15,590 bytes)
25. Re: [Amps] 220V service for amplifier (score: 1): Author: Ed Briggs <edbriggs@optonline.net>; Date: Sat, 06 Dec 2003 08:18:37 -0500; I've seen many old installations where the neutral was fused with a discrete fuse (not a ganged circuit breaker) . It's really easy to open the neutral in this case. These installations were in resid; /archives//html/Amps/2003-12/msg00077.html (12,512 bytes)
26. RE: [Amps] 220V service for amplifier (score: 1): Author: R.Measures <r@somis.org>; Date: Fri, 5 Dec 2003 18:24:59 -0800; ** please describe your antenna and feedline. Tnx _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps; /archives//html/Amps/2003-12/msg00080.html (8,995 bytes)
27. Re: [Amps] 220V service for amplifier (score: 1): Author: Bill Turner <wrt@dslextreme.com>; Date: Sat, 06 Dec 2003 12:39:32 -0800; On Sat, 06 Dec 2003 08:18:37 -0500, Ed Briggs <edbriggs@optonline.net> wrote: _________________________________________________________ LOL! Made my day. -- Bill, W6WRT ______________________________; /archives//html/Amps/2003-12/msg00095.html (8,469 bytes)

Current List: 21 - 27
Page: [1] [2]