- 1. [Amps] 813 Filament Transformer (score: 1)
- Author: "Steve Flood" <flood@ixi.net>
- Date: Tue, 23 Jan 2007 04:45:15 -0700
- I am building a 2x 813 amp and am looking for a filament transformer. I need some coaching on a couple options since I cannot seem to locate a proper 10V 10A transformer. 1) Use a 13v @ 20A transform
- /archives//html/Amps/2007-01/msg00242.html (6,421 bytes)
- 2. Re: [Amps] 813 Filament Transformer (score: 1)
- Author: Steve Thompson <g8gsq@eltac.co.uk>
- Date: Wed, 24 Jan 2007 12:27:01 +0000
- Either should work fine - it's fairly uncritical. I used a pair of 4.5V 50VA transformers - 4.5V is a common stock voltage over here - which also provides a convenient centre tap. Don't forget to rem
- /archives//html/Amps/2007-01/msg00244.html (7,097 bytes)
- 3. Re: [Amps] 813 Filament Transformer (score: 1)
- Author: "Robert B. Bonner" <rbonner@qro.com>
- Date: Wed, 24 Jan 2007 07:40:07 -0600
- You possibly could use a transformer out of an old battery charger. These usually were half wave power supplies with no filter cap and 6 and 12 v switch over here anyway. (center tapped) You could th
- /archives//html/Amps/2007-01/msg00245.html (9,231 bytes)
- 4. Re: [Amps] 813 Filament Transformer (score: 1)
- Author: Peter Chadwick <g3rzp@g3rzp.wanadoo.co.uk>
- Date: Wed, 24 Jan 2007 17:35:56 +0100 (CET)
- Another possibility is to use the 13 volt transformer with a 25 ohm, 30 watt resistor in the primary. You might want to make it an adjustable resistor, but it would have the additional advantage that
- /archives//html/Amps/2007-01/msg00246.html (7,390 bytes)
This search system is powered by
Namazu