- 21. [Amps] Arcing (score: 1)
- Author: on4kj at skynet.be (on4kj)
- Date: Sat Mar 8 10:25:44 2003
- produce transformer voltage. feeder meets for 2 stators! ** Remember the Fourier Analyse of a square wave. Transition phenomena are very near of square wave, the seventh harmonic ,there are only the
- /archives//html/Amps/2003-03/msg00335.html (9,929 bytes)
- 22. [Amps] Arcing (score: 1)
- Author: nagato at arnet.com.ar (GGLL)
- Date: Sat Mar 8 11:45:39 2003
- rlm escribi?: In past lab practice tests at school we drove some relay coils on-off frequently, and as Rich, have measured (...) pulses upto 800 V across the coil, with nominal operating value; then
- /archives//html/Amps/2003-03/msg00339.html (8,973 bytes)
- 23. [AMPS] ARCING (score: 1)
- Author: CATALANO_DENIS_E@hq.navsea.navy.mil (CATALANO_DENIS_E@hq.navsea.navy.mil)
- Date: Tue, 14 Apr 1998 08:30:18 -0400
- Greetings. I have a TENTEC Centurion (pair of 3-500Z) that has worked great for several years. Used it this weekend to work the H40 on RTTY. Although I worked the H40, the amp started arcing (because
- /archives//html/Amps/1998-04/msg00088.html (7,583 bytes)
- 24. [AMPS] ARCING (score: 1)
- Author: km1h@juno.com (km1h @ juno.com)
- Date: Tue, 14 Apr 1998 12:16:25 EDT
- On Tue, 14 Apr 1998 08:30:18 -0400 CATALANO_DENIS_E@hq.navsea.navy.mil writes: I would suggest opening it up first and do a visual inspection....saves us all a lot of time. It might be as simple as f
- /archives//html/Amps/1998-04/msg00089.html (8,257 bytes)
- 25. [AMPS] ARCING (score: 1)
- Author: measures@vc.net (Rich Measures)
- Date: Tue, 14 Apr 98 21:30:28 -0800
- What is the measured resistance of R1 and R2 (100 ohms) on the 81543 Plate Connector Board assembly? -- note -- one end of each resistor must be unsoldered to make these measurements. . Do you have
- /archives//html/Amps/1998-04/msg00093.html (7,931 bytes)
- 26. [Amps] ARCING (score: 1)
- Author: Herzog <herzog@frontiernet.net>
- Date: Wed, 19 May 2010 21:25:31 -0400
- RE: If the turning of the Load cap to the left resulted in under-coupling and caused the arc, I'm not sure how to proceed, because output was very low with the Load cap set at 5. Comments, ideas, adv
- /archives//html/Amps/2010-05/msg00212.html (7,140 bytes)
This search system is powered by
Namazu