Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Amps\]\s+Coax\s+jumper\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Amps\]\s+Coax\s+jumper\s*$/: 6 ]

Total 6 documents matching your query.

1. [Amps] Coax jumper (score: 1): Author: stewgoat at indy.net (Jeff Stewart); Date: Wed Jun 11 08:09:25 2003; Do I need RG-8 between my SB-200 and antenna tuner or will RG-58 handle it. Also I will use a relay box between the solid state radio and the amp to key it. Does this need to be in a sheilded box sin; /archives//html/Amps/2003-06/msg00069.html (6,849 bytes)
2. [Amps] Coax jumper (score: 1): Author: n3ji at yahoo.com (Joe Isabella); Date: Thu Jun 12 07:46:16 2003; You're probably pushing it with RG-58 -- I'd use at least Mini 8 (RG-8X). Joe, N3JI __________________________________ Do you Yahoo!? Yahoo! Calendar - Free online calendar with sync to Outlook(TM).; /archives//html/Amps/2003-06/msg00073.html (7,561 bytes)
3. [Amps] Coax jumper (score: 1): Author: vic at rakefet.com (Vic Rosenthal); Date: Thu Jun 12 07:46:20 2003; RG58 will be fine, but make sure the connectors are installed properly (this goes for any type of coax, of course). As a matter of course I always recommend shielding control circuits and using shiel; /archives//html/Amps/2003-06/msg00074.html (7,191 bytes)
4. [Amps] Coax jumper (score: 1): Author: RMcGraw at Blomand.Net (Robert & Linda McGraw K4TAX); Date: Fri Jun 13 08:31:46 2003; I seem to recall that RG-58 is rated at 600 watts at frequencies below 30 MHz. This presumes a matched load i.e VSWR at 1:1 which is what should exist between the amp and the tuner except during "tun; /archives//html/Amps/2003-06/msg00079.html (8,479 bytes)
5. [Amps] Coax jumper (score: 1): Author: vic at rakefet.com (Vic Rosenthal); Date: Fri Jun 13 08:31:51 2003; The limitation in this case is current, not voltage breakdown, so the duty cycle is relevant. I believe the 600 watt limit refers to 100 percent duty cycle, so assuming a CW duty cycle of 50 percent; /archives//html/Amps/2003-06/msg00081.html (7,640 bytes)
6. [Amps] Coax jumper (score: 1): Author: G3SEK at ifwtech.co.uk (Ian White, G3SEK); Date: Sat Jun 14 08:46:37 2003; What really gets warm is the center conductor - you don't feel it from the outside, but it softens the polyethylene. If there is a permanent sharp bend in the cable, the problem is a very slow migrat; /archives//html/Amps/2003-06/msg00085.html (9,469 bytes)

Current List: 1 - 6
Page: [1]