My Goodness! I just picked up a new old stock Peter Dahl XFMR. Based on what I know, it probably was built around 2002-or 3. It is tapped to supply 3KV, 4KV, 5KV and 6KV at .9 amps. The input side gi
The driver.... 3kv at .9 is just getting an 8877 warm. -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. ________________________________
As you apparently have no use for it, I'll bid twenty bucks to start things rolling.<:-)) 73 Roger (K8RI) _______________________________________________ Amps mailing list Amps@contesting.com http://
Its perfect for 1 or 2 4-1000A's which used to be a very popular tube. Carl KM1H _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mail
What's the model number? It may still be on the Harbach/Dahl site. It'd be really good for building an amp that could loaf right along at full legal limit in any mode. -- Mike Andrews, W5EGO mikea@mi
$50! -- Mike Andrews, W5EGO mikea@mikea.ath.cx Tired old sysadmin _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/am
In commercial service, the 5KV tap would work for a single 4CX1500B. (and running 208vac the 6kv tap might be used ) Don WA4NPL [Hide Quoted Text] My Goodness! I just picked up a new old stock Peter
Thats about what it will cost to get here! Carl KM1H _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps
I dont think so Don, thats a bit over 7KV DC. Just right for a 4X1 in full bloom (-; Carl KM1H _______________________________________________ Amps mailing list Amps@contesting.com http://lists.conte
I hope you didn't throw out your back when you picked it up :^) Bob, N7XY _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/lis
Van, How much does the transformer weigh? I'm guessing around 50 lbs if it is 900 ma. Based on a purchase I made from W8CQ who is handling Dahl designs with Magcap, I estimate ur transformer new woul
I mistyped ... I had a (FIVE) 5CX1500B running 5KV at .6 amps for years. Don WA4NPL _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/m