- 1. [Amps] Question on soft start board location on a SB1000 (score: 1)
- Author: Mike Krzystyniak <k9mk@flash.net>
- Date: Thu, 7 Nov 2013 10:43:51 -0800 (PST)
- I am installing a Harback SS-100 into a SB-1000 for a friend. The instructions suggest it be glued in place with some RTV or something similar. I was thinking contact cement or maybe double stic
- /archives//html/Amps/2013-11/msg00109.html (8,648 bytes)
- 2. Re: [Amps] Question on soft start board location on a SB1000 (score: 1)
- Author: Bill Turner <dezrat1242@yahoo.com>
- Date: Thu, 07 Nov 2013 15:01:44 -0800
- ORIGINAL MESSAGE: (may be snipped) REPLY: I installed a homebrew step-start board on top of the power transformer as you suggested. Its been about 20 years, but as best I recall I fabricated some mou
- /archives//html/Amps/2013-11/msg00122.html (8,907 bytes)
- 3. Re: [Amps] Question on soft start board location on a SB1000 (score: 1)
- Author: Jim W7RY <w7ry@centurytel.net>
- Date: Fri, 08 Nov 2013 08:53:57 -0800
- I just installed one of my step starts into an SB-1000. I used a 6-32 standoff about 1 inch long. I removed the nut on the screw holding the ground wire from the power cord to the chassis. Then insta
- /archives//html/Amps/2013-11/msg00146.html (9,898 bytes)
This search system is powered by
Namazu