Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Amps\]\s+clipperton\s+l\s+low\s+output\s+on\s+ssb\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Amps\]\s+clipperton\s+l\s+low\s+output\s+on\s+ssb\s*$/: 3 ]

Total 3 documents matching your query.

1. [Amps] clipperton l low output on ssb (score: 1): Author: mike vititoe <afa7mv@gmail.com>; Date: Tue, 19 Feb 2019 04:40:01 -0600; Ok I bought a clipperton l used unknown condition. I installed new harbach power supply board, new 572b tubes, resoldered some bad solder joints. I have 2700v pv and it is doing 1000w on cw but seems; /archives//html/Amps/2019-02/msg00051.html (6,582 bytes)
2. Re: [Amps] clipperton l low output on ssb (score: 1): Author: Victor Rosenthal 4X6GP <k2vco.vic@gmail.com>; Date: Tue, 19 Feb 2019 18:53:01 +0200; If you are looking at an average-reading power meter, then the output on SSB will look much lower than on CW because of the low duty cycle. If your power meter has a peak-reading mode, that's what yo; /archives//html/Amps/2019-02/msg00052.html (8,368 bytes)
3. Re: [Amps] clipperton l low output on ssb (score: 1): Author: John Simmons <jasimmons@pinewooddata.com>; Date: Tue, 19 Feb 2019 13:23:53 -0600; Did you try it with the alc disconnected? Start with low drive from the exciter. 73, -John NI0K mike vititoe wrote on 2/19/2019 4:40 AM: Ok I bought a clipperton l used unknown condition. I installed; /archives//html/Amps/2019-02/msg00053.html (7,778 bytes)

Current List: 1 - 3
Page: [1]