sorry...no beans... -Charles Hello All Does anyone know if Karlnet makes a configurator for Linux. I have been looking around and only see one available for windows..... And I REALLY hate having to u
Does anyone know the algorithm to convert the INTEGER values returned from the OIDs for signal and noise into dB values? A signal value of 86 and noise value of 10 aren't as helpful as the dB values.
Anybody else have AP-1000's that ocassionally lose a radio interface and require a reboot to restore it? This is really getting old! grr.. (it's an orinoco COR 4.15, so I'm sure there could be a prob
Actually, yes. We've had strange, random lockups of both wireless interfaces under Karlnet 4.31 and 4.43 on one of our AP-1000's. Haven't been able to trace it back to anything specific. -Ben. Anybod
Kevin and anyone interested, The problem I described yesterday with the kn200 boards has been partially resolved. The p2p link between the satellite units was due to the remote sat power supply being
Laroy, I did get a response today. The KN-200 should be able to support 2 200mw cards. Only possible issue is it will generate more heat! So make sure you use an enclosure that provides a way to help
Kevin, I have a chart that you sent me showing the voltage-vs-length for PoE. It shows that for about 185 - 200 ft the voltage should be 16 to 17 volts for the kn200. Does the card output matter in t
In the past, we have had 2 symptoms that need to be differentiated: 1) A radio interface completely stops sending (keeps receiving). This not only happened at CORs, also at the CPEs. The solution was
Thanks Thomas. Good suggestions. Unfortunately, our symptoms do not match either condition, and we are already blocking snmp at our edge for all our APs. -Ben.
Laroy, Card output power is NOT the issue! True, our first run of boards required calculations on the power supply, but ONLY if you were using PoE. The extra voltage with the power supply you have te
I've left messages, and today it says his mailbox is full. Anyone know what is going on? I need to get some high power cards for some RGs. Anyone have any suggestions? Thanks Bill
I have a new client (potential) that is asking me that I'm sure our wireless can handle her VPN application. Currently, when I set up a new user I do it with private IP address and outgoing NAT. Will