- 1. [TenTec] 4-pin inline male mic jack (score: 1)
- Author: mark@microenh.com (Mark Erbaugh)
- Date: Thu, 29 Nov 2001 11:01:03 -0500
- Does anyone have a source for a 4-pin inline male mic jack (one that I could plug a 705 mic into)? I just purchase a RigBlaster Plus for use with my Omni V and Pegasus. It comes with 8 pin connectors
- /archives//html/TenTec/2001-11/msg00296.html (8,375 bytes)
- 2. [TenTec] 4-pin inline male mic jack (score: 1)
- Author: geraldj@isunet.net (Dr. Gerald N. Johnson, electrical engineer)
- Date: Thu, 29 Nov 2001 12:37:06 -0600
- Hosfelt 800-524-6464 Cat no 4ILC, $3.50 73, Jerry, K0CQ -- Entire content copyright Dr. Gerald N. Johnson. Reproduction by permission only.
- /archives//html/TenTec/2001-11/msg00302.html (8,228 bytes)
- 3. [TenTec] 4-pin inline male mic jack (score: 1)
- Author: N4NT@chartertn.net (Mike Hyder)
- Date: Thu, 29 Nov 2001 12:32:46 -0500
- With most of those plugs/jacks, you can remove the black part which has the pins by removing a small screw. Then you could take a chassis one and put it into an inline case. Mike could Omni adapter w
- /archives//html/TenTec/2001-11/msg00313.html (9,434 bytes)
- 4. [TenTec] 4-pin inline male mic jack (score: 1)
- Author: rohre@arlut.utexas.edu (Stuart Rohre)
- Date: Thu, 29 Nov 2001 16:06:37 -0600
- Hi Mark, A little known fact, is often there are parts of phone plug covers for inline that will fit some chassis jacks. Experiment around at Radio Shack or your junk box, and see if you can use a pl
- /archives//html/TenTec/2001-11/msg00319.html (8,978 bytes)
- 5. [TenTec] 4-pin inline male mic jack (score: 1)
- Author: aluscre@neo.rr.com (Anthony A. Luscre)
- Date: Thu, 29 Nov 2001 18:18:54 -0500
- My technique to create "in-line" sockets/adapters for a variety of connectors is to use a panel mount connector and a plastic 35mm film containers. I use a hand reamer to put hole for jack in bottom
- /archives//html/TenTec/2001-11/msg00321.html (10,339 bytes)
This search system is powered by
Namazu