Reading what had been posted on the topic of locating a 9 MHz tap on an older EAGLE I opened up my EAGLE to investigate. What I found on the left side of the rig was a small pc board mounted by one s
It sounds like someone tapped the 9MHz i.f. and ran it out through a Clifton Labs buffer amp. This is a user applied mod. Barry N1EU _______________________________________________ TenTec mailing lis
David, I think you are mistaken. 9MHz is not present at that point. If (and only if) we both are referring to the same tiny board mounted vertically, the signal on that board is the antenna line, bet
HDSDR works well with Ensemble II. My N4PY software will marry the Eagle and HDSDR. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com Barry N1EU Reading what had been posted on the to
I see Ten Tec has a page on adding a tap for SDR. Is this applicable to this discussion, or are different revision levels? Pete https://www.tentec.com/content/downloads/manuals/599/599%20EAGLE%20RADI
All, There has to be a newer (revision) version as my Eagle does not correspond to this. 73 de Pepe WP3HW I see Ten Tec has a page on adding a tap for SDR. Is this applicable to this discussion, or a
No, it has nothing to do with 9 MHz. It is about adding a 2nd RX by sharing the antenna line within the Eagle. 73 - Rick, DJ0IP (Nr. Frankfurt am Main) I see Ten Tec has a page on adding a tap for SD
Well, I must be out to lunch, but this is topic asking about a 9 MHz tap on an Eagle. If the topic is about adding a full SDR receiver, capable of providing CW skimmer operations over several band se
Dave, We have been discussing both ways of connecting an SDR. The trouble is, the very first production run of Eagles did not have the TMP jack with the 9 MHz tap on the Filter Board. However there w
In this case, Dave = Pete (had two emails open at once and grabbed the wrong name) 73 - Rick, DJ0IP (Nr. Frankfurt am Main) Dave, We have been discussing both ways of connecting an SDR. The trouble i