- 1. [TenTec] Argonaut V Transmit Audio (score: 1)
- Author: Don Rasmussen <wb8yqj@yahoo.com>
- Date: Tue, 10 Jan 2006 13:43:05 -0800 (PST)
- Toby, Assuming your unit shipped with 1.08, or came to you within the last year, you have the hardware changes. If the audio is "thin", then I suppose it's time to send the unit back to get that fixe
- /archives//html/TenTec/2006-01/msg00379.html (7,612 bytes)
- 2. Re: [TenTec] Argonaut V Transmit Audio (score: 1)
- Author: "Toby Pennington" <toby423@earthlink.net>
- Date: Tue, 10 Jan 2006 18:10:24 -0500
- Don, I contacted Jack Burchfield today about the thin audio and he said the audio rolls off 6DB at 350hz. He said they would look at the DSP and see if they can pump it up at the low end. Hope they c
- /archives//html/TenTec/2006-01/msg00382.html (10,255 bytes)
- 3. Re: [TenTec] Argonaut V Transmit Audio (score: 1)
- Author: "Brad Johnson" <aa5ch@cox.net>
- Date: Tue, 10 Jan 2006 17:39:40 -0600
- I've done some experimentation with different mics for the Argonaut V and never been completely satisfied with its TX audio quality. Since four pin Kenwood mics will work on some Ten Tec gear without
- /archives//html/TenTec/2006-01/msg00384.html (7,487 bytes)
- 4. Re: [TenTec] Argonaut V Transmit Audio (score: 1)
- Author: Ronald Hands <rhands@mountaincable.net>
- Date: Tue, 10 Jan 2006 19:12:46 -0500
- I don't have an Argonaut V (never even seen one, in fact), but I found the best audio reports from my Corsair II came when I was using a Shure 444. Anybody tried one of these on an Argonaut V? -- Ron
- /archives//html/TenTec/2006-01/msg00386.html (7,663 bytes)
- 5. [TenTec] Argonaut V Transmit Audio (score: 1)
- Author: Don Rasmussen <wb8yqj@yahoo.com>
- Date: Tue, 10 Jan 2006 16:38:49 -0800 (PST)
- Thanks to Toby for contacting Jack B., and passing along that info. If the DSP is limiting at 350hz, that's what I would call communications quality, as compared to a defect. I experimented with the
- /archives//html/TenTec/2006-01/msg00387.html (7,227 bytes)
- 6. Re: [TenTec] Argonaut V Transmit Audio (score: 1)
- Author: "Dave Edwards" <kd2e@comcast.net>
- Date: Tue, 10 Jan 2006 19:21:01 -0500
- My Argo V had horrible audio until I sent it back for the upgrade. Now it seems fine....or at least I've not received any bad audio reports..as I used to. I use an old Turner +2 CB microphone on it.
- /archives//html/TenTec/2006-01/msg00393.html (8,684 bytes)
- 7. Re: [TenTec] Argonaut V Transmit Audio (score: 1)
- Author: Graham Wright <graham-g4fuj@talk21.com>
- Date: Wed, 11 Jan 2006 08:52:49 +0000 (GMT)
- I'm susing a Shure 444 on my Paragon 585. Got the nickname "Mr. Smooth Audio" from a couple of friends on a regular net! 73 Graham G4FUJ Paragon 585 229 ATU Argosy II 525D Scout 555 _________________
- /archives//html/TenTec/2006-01/msg00404.html (8,474 bytes)
- 8. Re: [TenTec] Argonaut V Transmit Audio (score: 1)
- Author: "Bill Rowlett" <kc4atu@hotmail.com>
- Date: Wed, 11 Jan 2006 11:15:22 +0000
- Always got good audio reports before and after the upgrade. Use the hand mic which came with my Argo 556 or an older 705 desk mic. Was not impressed with the hand mic which came with the 516. kc4atu
- /archives//html/TenTec/2006-01/msg00438.html (10,182 bytes)
- 9. Re: [TenTec] Argonaut V Transmit Audio (score: 1)
- Author: ron <roncasa@verizon.net>
- Date: Thu, 12 Jan 2006 09:34:23 -0500
- aren't both handheld mikes the same?? Ron wb1hga _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
- /archives//html/TenTec/2006-01/msg00452.html (7,858 bytes)
- 10. Re: [TenTec] Argonaut V Transmit Audio (score: 1)
- Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
- Date: Thu, 12 Jan 2006 09:26:08 -0600
- With all of these electret mikes, yes they are basically the same. But at the same time, they are uniquely different. I have both the 705 desk mike, the 701 hand mike and the Heil/Tentec special edit
- /archives//html/TenTec/2006-01/msg00453.html (10,882 bytes)
This search system is powered by
Namazu