Hello to the list, I am using DXLab and N1MM+ with my Eagle. Both programs work nicely until I press the key, then the com port goes dumb and the PC no longer follows the radio. Sure sounds like RF i
Turn tx power down to see if there is a power level that does not cause the problem, just to confirm it really is an RF problem. Try connecting radio directly to dummy load and see if problem goes aw
try with dummy load. try a different USB cable. does it happen on all bands? 73, -bob ah7i -- -do not look into LASER with remaining eye! _______________________________________________ TenTec mailin
are you using the more than one cable to the laptop? try keying rig with only the USB control cable and a manual key. -- -do not look into LASER with remaining eye! __________________________________
Hi Bob, This is my vacation setup so I do not have access to much else, not even a dummy load. I did order a double-shielded USB cable which should get here next week. I disconnected everything from
Author: Michael Chowning <mike.chowning@mgccc.org>
Date: Thu, 13 Jul 2017 15:40:58 -0400
Can you remove the laptop battery, and run both off an grounded external dc battery supply? Mike, N8TTR _______________________________________________ TenTec mailing list TenTec@contesting.com http:
A different length of cable, could be helpful to diagnose the issue. Have a great day, --... ...-- Dale - WC7S in Wy "Actions speak louder than words" 1856 - Abraham Lincoln Hi Bob, This is my vacati