- 1. [TenTec] Heil HC-4 and Orion (score: 1)
- Author: Bill Tippett <btippett@alum.mit.edu>
- Date: Sat, 08 Nov 2003 11:46:44 -0500
- Has anyone been able to successfully use the HC-4 with Orion? I've tried two different elements and many MIC and SP different settings but cannot seem to find any combination which is not clipping th
- /archives//html/TenTec/2003-11/msg00202.html (6,971 bytes)
- 2. Re: [TenTec] Heil HC-4 and Orion (score: 1)
- Author: Duane A Calvin <ac5aa@juno.com>
- Date: Sat, 8 Nov 2003 11:05:17 -0600
- Ha, ha, ha - the HC4 clips the audio. I have yet to hear one that I'd pay anything for. I find their audio piercing and less intelligible than practically any other microphone. (Go ahead, turn me in
- /archives//html/TenTec/2003-11/msg00204.html (8,192 bytes)
- 3. Re: [TenTec] Heil HC-4 and Orion (score: 1)
- Author: "Carl Moreschi" <n4py@earthlink.net>
- Date: Sat, 8 Nov 2003 17:59:10 -0000
- Bill, I have the Heil Goldline mic with the HC-4 element as the second element or DX element. It works fine with my Orion. I get good audio reports from my son monitoring my signal about 10 miles awa
- /archives//html/TenTec/2003-11/msg00205.html (9,509 bytes)
- 4. Re: [TenTec] Heil HC-4 and Orion (score: 1)
- Author: Bill Miner <wg6h@postoffice.pacbell.net>
- Date: Sat, 08 Nov 2003 12:05:19 -0800
- Bill, I am using the HC-5 element with my ORION and it seems to work pretty well. Audio reports are favorable from people that know my voice. Even the HC-5 does not have a lot of bass response but yo
- /archives//html/TenTec/2003-11/msg00207.html (8,806 bytes)
- 5. Re: [TenTec] Heil HC-4 and Orion (score: 1)
- Author: ac5e@comcast.net
- Date: Sat, 08 Nov 2003 22:28:14 +0000
- ON4UN and I did some on-air speech processing comparing and found there's no appreciable audio distortion even when the Orion's RF SP is set very high. John says he runs his around 5, my audiophile f
- /archives//html/TenTec/2003-11/msg00209.html (9,721 bytes)
- 6. Re: [TenTec] Heil HC-4 and Orion (score: 1)
- Author: Dave Heil <k8mn@earthlink.net>
- Date: Sun, 09 Nov 2003 04:34:41 +0000
- ...and then set TX low end rolloff for about 200 Hz and TX EQ at +8. Those worked for me. I usually use an HC-5 but the old element went west and I had a new HC-4 sitting around. Dave K8MN __________
- /archives//html/TenTec/2003-11/msg00214.html (8,482 bytes)
- 7. Re: [TenTec] Heil HC-4 and Orion (score: 1)
- Author: Dave Heil <k8mn@earthlink.net>
- Date: Sun, 09 Nov 2003 04:37:48 +0000
- I neglected to add that after adjusting the mike preamp, I run my microphone gain at 57 with the HC-4/Proset. 73, Dave K8MN _______________________________________________ TenTec mailing list TenTec@
- /archives//html/TenTec/2003-11/msg00215.html (8,079 bytes)
- 8. [TenTec] Heil HC-4 and Orion (score: 1)
- Author: Bill Tippett <btippett@alum.mit.edu>
- Date: Mon, 10 Nov 2003 07:06:53 -0500
- Thanks to all who replied...just a quick followup. Most who were successfully using both HC-4 and HC-5 were using much higher MIC settings than I had been using. I tried adjusting MIC as the new manu
- /archives//html/TenTec/2003-11/msg00249.html (8,809 bytes)
- 9. Re: [TenTec] Heil HC-4 and Orion (score: 1)
- Author: "Ten-Tec Inc. Amateur Radio Sales" <sales@tentec.com>
- Date: Mon, 10 Nov 2003 17:07:08 -0500
- At 07:06 AM 11/10/03 -0500, you wrote: Thanks to all who replied...just a quick followup. Most who were successfully using both HC-4 and HC-5 were using much higher MIC settings than I had been using
- /archives//html/TenTec/2003-11/msg00262.html (10,395 bytes)
This search system is powered by
Namazu