Allen, The way I read Bernie's question, he is asking about the thicker solid line that is directly above the spectrum display. There is a "break" (it becomes a thin line) in it just between the "0"
That is the line I assumed Bernie was referring to also, and it still remains a mystery! I am sitting here trying to change it, and sometimes and can and then, I can't make it change again. It looks
I'm an Orion 1 owner and still can't figure out what in the hell these rectangles are. And the manual is totally useless. I suppose I'm to read the mind of the designer to divine what the rectangles
The horizontal lines just represent the maximum range the bandwidth rectangles can move. The break in the line is just to separate the line for the main receiver side and the sub receiver side. If yo
I opened up the BW to 6K then switched to PBT and adjusted that through it's range. I can see and hear what is happening; however, what is happening eletronically? -- Original Message -- From: "Carl
The DSP code in the firmware is doing all the changing to accomplish this. Very little is happeining electronically. Carl Moreschi N4PY 121 Little Bell Drive Bell Mountain Hays, NC 28635 -- Original
I look forward to the day when Ten Tec has the talent/desire to create a better interface. They have the radio fundamental part down pat, but the interface is a major let down for me after having a P