I have observed this, and it doesn't seem to affect operation, but it is very odd... Only happens in the 28.0 and 29.0 bands. When rotating the RESONATE control through the 7-14 MHz region, I hit the
Author: "Dr. Gerald N. Johnson" <geraldj@weather.net>
Date: Tue, 06 Apr 2010 13:33:23 -0500
That's usually how oscillating RF stages are detected. Such oscillation often does affect operation by mixing in out of band signals and noise to obscure signals on the desired band. The question tha
Greetings to the net: I have a stock Corsair II that has been idle for about 4 months due to some family health issues. I turned it on yesterday and found the display only reads 9.0000 or 91.0000 no
Dude, threadjacking? David Goncalves W1EUJ -- David Goncalves _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/te
Author: "Dr. Gerald N. Johnson" <geraldj@weather.net>
Date: Tue, 06 Apr 2010 18:06:46 -0500
Is the PTO jumper in place on the back panel? Does it tune on a band that is sure to have signals? If it tunes that jumper is in place, but the counter isn't seeing signal. There are two jumpers need
Found it. Made an error in RF Amplifier alignment. Reperformed procedure, and condition cleared up. Funny that! David Goncalves _______________________________________________ TenTec mailing list Ten