- 1. [TenTec] Omni C (Model 546C) front end... (score: 1)
- Author: "Dave Plews" <djplews@comcast.net>
- Date: Thu, 27 May 2010 13:07:49 -0500
- L1 (p/n 85097) needs replacement on the RF amp board (p/n 80460). Does anyone have experience with this? What about parts? Ten Tec does not have the L1 coil in stock and no replacement. Ideas? Thanks
- /archives//html/TenTec/2010-05/msg00433.html (7,394 bytes)
- 2. Re: [TenTec] Omni C (Model 546C) front end... (score: 1)
- Author: David Goncalves <davegoncalves@gmail.com>
- Date: Thu, 27 May 2010 14:48:23 -0400
- Unless somebody can pull it out from a scrap unit, you may have to rewind it. David Goncalves W1EUJ -- David Goncalves _______________________________________________ TenTec mailing list TenTec@conte
- /archives//html/TenTec/2010-05/msg00438.html (7,887 bytes)
- 3. Re: [TenTec] Omni C (Model 546C) front end... (score: 1)
- Author: "Dr. Gerald N. Johnson" <geraldj@weather.net>
- Date: Thu, 27 May 2010 15:04:52 -0500
- What happened to it? Lightning? Stuck TR switch? Mouse? I don't have the circuit handy but its likely a fairly common style of construction for Tentec. Very likely another input coil from another ban
- /archives//html/TenTec/2010-05/msg00447.html (8,967 bytes)
- 4. Re: [TenTec] Omni C (Model 546C) front end... (score: 1)
- Author: "Dave Plews" <djplews@comcast.net>
- Date: Thu, 27 May 2010 16:23:32 -0500
- Hi Jerry, I'm not sure what happened to it. It's been dormant for a long time and I took it out of storage. Played with it a bit and noted that the sensitivity wasn't nearly as good as it should espe
- /archives//html/TenTec/2010-05/msg00449.html (10,322 bytes)
- 5. Re: [TenTec] Omni C (Model 546C) front end... (score: 1)
- Author: "Dr. Gerald N. Johnson" <geraldj@weather.net>
- Date: Thu, 27 May 2010 17:11:09 -0500
- RF coils don't go bad often, and then its one of the causes I mentioned, lightning or transmit power and then it usually shows up with smoke residue in the vicinity. I nearly always expect the transi
- /archives//html/TenTec/2010-05/msg00450.html (10,233 bytes)
- 6. Re: [TenTec] Omni C (Model 546C) front end... (score: 1)
- Author: "Rick - NJ0IP / DJ0IP" <Rick@DJ0IP.de>
- Date: Thu, 27 May 2010 18:28:37 -0500
- Or... cold solder joint. Check it. Just re-solder all the connections. --Original Message-- From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com] On Behalf Of Dr. Gerald N. Johns
- /archives//html/TenTec/2010-05/msg00454.html (11,132 bytes)
This search system is powered by
Namazu