- 1. [TenTec] Omni C help.... (score: 1)
- Author: Jerry Kitterman <jerry.kitterman53@yahoo.com>
- Date: Sun, 6 Sep 2009 12:59:45 -0700 (PDT)
- I just received a new dc connector for the back of the Omni. Now, just how do I go about removing the old one and installing the new? The leads are so short you could never cut them. Can a hot solder
- /archives//html/TenTec/2009-09/msg00062.html (7,555 bytes)
- 2. Re: [TenTec] Omni C help.... (score: 1)
- Author: geoffrey mendelson <geoffreymendelson@gmail.com>
- Date: Sun, 6 Sep 2009 23:06:24 +0300
- If it's a MOLEX connector, you can use a small screwdriver to bend the tab that holds them in so they pop out the other end. You go in from the "front" and they pop out the back. You can practice on
- /archives//html/TenTec/2009-09/msg00063.html (8,084 bytes)
- 3. Re: [TenTec] Omni C help.... (score: 1)
- Author: "Bob Close" <rclose@nhwisp.com>
- Date: Sun, 6 Sep 2009 16:57:01 -0400
- A piece of brass tubing in the appropriate size from your local hardware store will also work slick as snot. If you are too cheap to purchase a piece, some of the brass tubes inside a pen will work.
- /archives//html/TenTec/2009-09/msg00065.html (8,811 bytes)
- 4. Re: [TenTec] Omni C help.... (score: 1)
- Author: "Gary Hoffman" <ghoffman@spacetech.com>
- Date: Sun, 6 Sep 2009 20:02:45 -0400
- Yes, of course you can still get "pin poppers"....otherwise known as pin insertion and removal tools. All the big suppliers sell them. You should have an assortment in the tool kit. They are availabl
- /archives//html/TenTec/2009-09/msg00067.html (9,645 bytes)
- 5. Re: [TenTec] Omni C help.... (score: 1)
- Author: "Dr. Gerald N. Johnson" <geraldj@weather.net>
- Date: Sun, 06 Sep 2009 20:25:35 -0600
- Its NOT a Molex, its an AMP. Different pin dimensions. The pins are probably crimped to the wires, not soldered. The pins release from the shells like Molex pins though, but probably take different t
- /archives//html/TenTec/2009-09/msg00072.html (8,661 bytes)
This search system is powered by
Namazu