Hi Everybody, The 'audio switch' that you refer to is actually done in the Main RX dsp. The only way to control it is with the AUDIO menu, where you can choose the signals for the Speaker, the Right
Hi Everybody, I need to correct a couple of things about my previous post. The AUDIO menu effects the audio going to the Left and Right headphone channels, as well as the Left and Right Aux Outputs.
Howard, I am using 3.032x5 V2 July 2013. Switching to Ant 2 does not solve the problem. NB/NR/Notch/SAF/AN are Off as is the SAF/Notch tracking. Also, there is no audio for the Sub receiver (or inter
So it's more than just no audio. It's no signals either. I would still bet on the cable connectors behind the front panel need cleaning. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.
Yes, cables, connectors or worse. Mike W8TRN -- Original Message -- From: "Carl Moreschi" <n4py3@earthlink.net> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> Sent: Sunday, October 25,
My bet is that there's a TMP cable disconnected on the subreceiver board. Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.
I thought he said it was intermittent at first. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com Barry N1EU Yes, cables, connectors or worse. So it's more than just no audio. It's no
It worked for a couple of weeks after return from Ten Tec. Then nothing. but a hiss. And it has been to TN twice for this problem. FWIW, I have done a googleplex of the reset routines. Next step is t
that what my sub receiver problems feels like.sometime it works, sometimes a hiss, sometimes some kind of indescribable noiseit has been back to TT for logic board replacement. Sometimes pressing the
My circumstance with this problem was taking the cover off would "cure" the problem for a while. Eventually it was tracked down to the relays in the eft rear corner of the rig - bad solder joints. Ta
Ok umpteenth time followup Call the tech at TT this am and he said to check out cable No 16goes between the filter board to the board just below the speaker.did so and cleaned with deoxit..so far so
yet another follow up lately been noticing that the sub receiver is deaf until the rig warms upthen have to go to 20 meters via sub receiver, switch between sub rx buttons, listen for hash on the VFO
Is it my imagination or are we beginning to reach the limit of the design life for Orions? All of a sudden it seems that the number of emails from people having strange problems with Orions has incre
I have posted this a few times: the sub receiver on my Orion 1 has been dead most of its life. A couple of trips to Ten Tec, works for a week or two then dead. Last time it worked was at least 3 year
For the recalcitrant sub reciever and receiver, open up the rig and reseat after cleaning the cable's connectors. But also, take a strong work light and magnifying glass and examine all the solder co