- 1. [TenTec] Orion not TXing (score: 1)
- Author: "Paul A. Ramey" <wg0g@arrl.net>
- Date: Sun, 29 Jun 2014 18:32:47 -0500
- I need some help. I have an Orion, 565. Turned it on today and RX working FB. When I tried to transmit, no power out, ALC light or meter movement while transmitting. I can RX on any band, the voice r
- /archives//html/TenTec/2014-06/msg00253.html (7,516 bytes)
- 2. Re: [TenTec] Orion not TXing (score: 1)
- Author: Carl Moreschi <n4py3@earthlink.net>
- Date: Sun, 29 Jun 2014 19:48:48 -0400
- Try the complete reset below. 1) Power off Orion. 2) Power On holding the VFO B LCK button. 3) Continue holding LCK button until the radio says "Battery Failure". 4) Power off Orion. 5) Power on hold
- /archives//html/TenTec/2014-06/msg00254.html (8,068 bytes)
- 3. Re: [TenTec] Orion not TXing (score: 1)
- Author: "g3ory@lineone.net" <g3ory@lineone.net>
- Date: Mon, 30 Jun 2014 08:53:05 +0100 (BST)
- Paul, One of probably several possibilities is the TX loop. Check the status in the menus and make sure it is OFF. 73 Bob G3ORY When I I function _______________________________________________ TenTe
- /archives//html/TenTec/2014-06/msg00258.html (8,322 bytes)
- 4. Re: [TenTec] Orion not TXing (score: 1)
- Author: "G3WPF" <g3wpf@sky.com>
- Date: Mon, 30 Jun 2014 11:49:08 +0100
- Also check that the power poles are properly seated in the back of the rig, especially if there has been any stress on the power cable externally. I had a similar problem and this was the cause. I ne
- /archives//html/TenTec/2014-06/msg00259.html (8,222 bytes)
- 5. [TenTec] Orion not TXing (score: 1)
- Author: John Henry <jhenry@tentec.com>
- Date: Mon, 30 Jun 2014 07:34:57 -0400
- Paul, Do you get power when you switch to CW mode? You can always call Paul Clinton in service, either him or Robert can walk you through 4 or 5 things that end up preventing TX. Thanks, and 73, John
- /archives//html/TenTec/2014-06/msg00260.html (7,368 bytes)
- 6. [TenTec] Orion not TXing (score: 1)
- Author: "Paul A. Ramey" <wg0g@arrl.net>
- Date: Wed, 02 Jul 2014 07:45:34 -0500
- Thanks to all that answered my posting. Resetting did not help, power cont was OK and making good contact. I called TT repair and after talking to them about the problem, looks like my CPU board coul
- /archives//html/TenTec/2014-07/msg00007.html (6,688 bytes)
This search system is powered by
Namazu