- 1. Re: [TenTec] Herc II followup (score: 1)
- Author: Michael Tortorella via TenTec <tentec@contesting.com>
- Date: Sat, 24 Sep 2022 17:53:43 -0600
- Hi Ken, I am driving it with a TT Orion with the keying connected as in the TT manual. No, it does not key at all yet. Have not tried the replaced control board yet, I have been out all afternoon put
- /archives//html/TenTec/2022-09/msg00046.html (9,371 bytes)
- 2. Re: [TenTec] TenTec Digest, Vol 237, Issue 12 (score: 1)
- Author: Jody Barefoot <aj.barefoot.wy1p@gmail.com>
- Date: Tue, 27 Sep 2022 00:57:28 -0400
- There is a "ball drive" vernier in there. Three ball bearings run in a groove on the shaft; works like a planetary gear drive. Cleaning and re lube might help, but sometimes the brass shaft gets
- /archives//html/TenTec/2022-09/msg00048.html (9,565 bytes)
- 3. Re: [TenTec] TenTec Digest, Vol 237, Issue 12 (score: 1)
- Author: Shawn Upton via TenTec <tentec@contesting.com>
- Date: Wed, 28 Sep 2022 01:06:42 +0000 (UTC)
- That is what I'm afraid of: wear in the brass shaft, necessitating future replacement. Oh well. It's not so bad right now; supposedly it was gone through shortly before I got it (I recall getting a
- /archives//html/TenTec/2022-09/msg00050.html (11,451 bytes)
This search system is powered by
Namazu