- 1. [TenTec] audio quality on Omni VI+ (score: 1)
- Author: "yash@aol.com" <yash@aol.com>
- Date: Wed, 8 May 2013 16:53:06 -0400 (EDT)
- Sitting here listening to the VI+,I find the audio is irritating ,at best, on ssb. I have read about the Inrad audio mod kit and was wondering if it is worth the effort? If anyone has used it sure wo
- /archives//html/TenTec/2013-05/msg00013.html (6,897 bytes)
- 2. Re: [TenTec] audio quality on Omni VI+ (score: 1)
- Author: "Robert Mcgraw" <rmcgraw@blomand.net>
- Date: Thu, 9 May 2013 11:57:36 -0500 (CDT)
- The INRAD kit reportedly improves the audio quality a bit. I think it is more subjective than anything else. One thing I've encountered in several units I've repaired is the accuracy of the BFO oscil
- /archives//html/TenTec/2013-05/msg00014.html (8,835 bytes)
- 3. Re: [TenTec] audio quality on Omni VI+ (score: 1)
- Author: Barry N1EU <barry.n1eu@gmail.com>
- Date: Thu, 9 May 2013 18:19:02 +0000
- The short answer is I don't think you'll be satisfied. For the long answer, read the top section at http://omni6.wikidot.com/rxaudio 73, Barry N1EU _______________________________________________ Ten
- /archives//html/TenTec/2013-05/msg00015.html (7,458 bytes)
- 4. Re: [TenTec] audio quality on Omni VI+ (score: 1)
- Author: wa5yom <wa5yom@swbell.net>
- Date: Fri, 10 May 2013 18:18:05 -0500
- I have an OMNI V, I am the original owner it has been kept is perfect condition, but recently the Transmit and receive has been intermittent.....per Ten-Tec.....it could cost more to fix than it is w
- /archives//html/TenTec/2013-05/msg00018.html (7,685 bytes)
- 5. Re: [TenTec] audio quality on Omni VI+ (score: 1)
- Author: Clayton Brantley <clayton_n4ev@yahoo.com>
- Date: Fri, 10 May 2013 17:28:45 -0700 (PDT)
- Tim: Try the usual, pulling the interconnecting board to board cables. One at a time. Sometimes DeOxit spray on each one (use sparingly) will clean up the connections. I usually take a small Phil
- /archives//html/TenTec/2013-05/msg00019.html (9,170 bytes)
- 6. Re: [TenTec] audio quality on Omni VI+ (score: 1)
- Author: "Paul Kraemer" <elespe@lisco.com>
- Date: Fri, 10 May 2013 20:24:05 -0500
- Tim A little more specificity on intermittent would be helpful Is there receiver noise at all or totally dead? Any display lights? Any meaningful display or just lights up? I recently repaired 563 th
- /archives//html/TenTec/2013-05/msg00020.html (9,133 bytes)
- 7. Re: [TenTec] audio quality on Omni VI+ (score: 1)
- Author: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
- Date: Fri, 10 May 2013 22:38:00 -0500
- More info is needed. Is this happening on all bands or specific ones? Could be a relay or relays on the LP Filter board. You have exercised the RX antenna switch on the rear, if not do so. A good cle
- /archives//html/TenTec/2013-05/msg00022.html (9,955 bytes)
- 8. Re: [TenTec] audio quality on Omni VI+ (score: 1)
- Author: wa5yom <wa5yom@swbell.net>
- Date: Fri, 10 May 2013 22:47:28 -0500
- On 5/10/2013 10:38 PM, Bob McGraw - K4TAX wrote: More info is needed. Is this happening on all bands or specific ones? Could be a relay or relays on the LP Filter board. You have exercised the RX ant
- /archives//html/TenTec/2013-05/msg00023.html (10,496 bytes)
- 9. Re: [TenTec] audio quality on Omni VI+ (score: 1)
- Author: Jim Goudie <jagoudie@comcast.net>
- Date: Fri, 10 May 2013 23:52:15 -0400
- Tim... Just jumping in with an obvious question that may not be obvious. Have you tried it without the tuner in line? Unless you've checked that out before, it could be a tuner problem... Jim, AF3Z _
- /archives//html/TenTec/2013-05/msg00024.html (9,597 bytes)
- 10. Re: [TenTec] audio quality on Omni VI+ (score: 1)
- Author: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
- Date: Fri, 10 May 2013 22:53:22 -0500
- Antenna tuner is external to the radio. How does this affect transmit? from your description of receive noise, it may be the external antenna tuner at fault. Or a defective coax jumper cable. 73 Bob,
- /archives//html/TenTec/2013-05/msg00025.html (11,570 bytes)
- 11. Re: [TenTec] audio quality on Omni VI+ (score: 1)
- Author: "Duane Calvin" <ac5aa1@gmail.com>
- Date: Fri, 10 May 2013 23:13:58 -0500
- Bypass the tuner and see if that isolates the problem. 73, Duane Duane Calvin, AC5AA Austin, Texas www.ac5aa.com All.....thanks for the advice..... Everything lights up........Periodically...all I
- /archives//html/TenTec/2013-05/msg00026.html (11,346 bytes)
- 12. Re: [TenTec] audio quality on Omni VI+ (score: 1)
- Author: Stuart Rohre <rohre@arlut.utexas.edu>
- Date: Sun, 12 May 2013 17:42:10 -0500
- I would reseat all interconnect cables plugs, as a first step. Also check the PTT switch for intermittents on your mike, in fact do that FIRST. GL, Stuart Rohre K5KVH ________________________________
- /archives//html/TenTec/2013-05/msg00038.html (9,105 bytes)
This search system is powered by
Namazu