- 1. [TenTec] orion11 (score: 1)
- Author: "Rodney" <w3krq@dejazzd.com>
- Date: Sun, 25 Oct 2015 14:53:14 -0400
- I am selling my ORION11 9.5 out of 10 has tuner 1800.00 shipped. _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo
- /archives//html/TenTec/2015-10/msg00195.html (6,341 bytes)
- 2. [TenTec] WG: Problems with Orion II (score: 1)
- Author: Evgeny Demchenko via TenTec <tentec@contesting.com>
- Date: Wed, 06 May 2020 19:27:08 +0300
- Hi. It is possible a processor malfunction. I had slightly different symptoms. The transceiver did not respond to the buttons .. Sometimes it worked. Everything was decided by replacing the processor
- /archives//html/TenTec/2020-05/msg00003.html (6,844 bytes)
- 3. [TenTec] orion11 (score: 1)
- Author: Rodney Dewald via TenTec <tentec@contesting.com>
- Date: Wed, 6 May 2020 21:43:06 -0400
- My orion comes on but nothing works does not do a reset do you think it the caps on the power board Sent from Mail for Windows 10 _______________________________________________ TenTec mailing list T
- /archives//html/TenTec/2020-05/msg00004.html (7,217 bytes)
- 4. Re: [TenTec] orion11 (score: 1)
- Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
- Date: Wed, 6 May 2020 20:50:45 -0500
- Rodney: Have they been changed or are they original? If original, then they should be replaced. Also the snapchat battery will likely need replacing. There is info on the site about a Bill Of Mat
- /archives//html/TenTec/2020-05/msg00005.html (8,019 bytes)
- 5. Re: [TenTec] orion11 (score: 1)
- Author: Rodney Dewald via TenTec <tentec@contesting.com>
- Date: Wed, 6 May 2020 21:55:13 -0400
- Yes I think the caps were changed Sent from Mail for Windows 10 Rodney: Have they been changed or are they original? If original, then they should be replaced. Also the snapchat battery will likel
- /archives//html/TenTec/2020-05/msg00006.html (7,977 bytes)
- 6. Re: [TenTec] orion11 (score: 1)
- Author: Bob McGraw K4TAX <rmcgraw@blomand.net>
- Date: Wed, 6 May 2020 21:26:26 -0500
- Then start cleaning connectors. Use a good contact cleaner, DeOxit, apply a small amount to a Q-Tip. Unplug each connector, and do this one at a time, scrub the male pins and then exercise the co
- /archives//html/TenTec/2020-05/msg00007.html (9,160 bytes)
This search system is powered by
Namazu