- 1. [TenTec] scout newbie (score: 1)
- Author: "Mark Banks (w6spt)" <mvbanks@banksglass.com>
- Date: Fri, 17 Dec 2004 15:29:21 -0800
- New to the list with a new to me scout. I have noticed a problem with my 20 meter module. The power output is only 10 watts into a dummy load. 80 and 40 meter modules yield full 50 watts with same se
- /archives//html/TenTec/2004-12/msg00647.html (6,877 bytes)
- 2. Re: [TenTec] scout newbie (score: 1)
- Author: "Stuart Rohre" <rohre@arlut.utexas.edu>
- Date: Fri, 17 Dec 2004 19:47:10 -0600
- Definitely a problem with the module. Check the integrity of the coaxial connections that carry the full final power. Check their solder joints and springs. Check the fingers on the board that carry
- /archives//html/TenTec/2004-12/msg00652.html (6,950 bytes)
- 3. Re: [TenTec] scout newbie (score: 1)
- Author: "David S.McCallum" <w7sac2@cox.net>
- Date: Fri, 17 Dec 2004 22:00:27 -0600
- Mark check the manual I think it says all you should get out 15w in the tune mode and in ssb you'll get pretty close to 50w. out put. Are you saying your getting 50w in the tune position?, Mac New to
- /archives//html/TenTec/2004-12/msg00655.html (8,732 bytes)
- 4. [TenTec] scout newbie (score: 1)
- Author: "Rick Williams" <rick.williams@telus.net>
- Date: Fri, 17 Dec 2004 20:37:21 -0800
- Mark I'd sure question the module! Take the module out and gently take a pencil eraser to the contacts. Clean it off and re-insert it and try again. It should read similar output into a dummy load wi
- /archives//html/TenTec/2004-12/msg00656.html (8,453 bytes)
- 5. Re: [TenTec] scout newbie (score: 1)
- Author: w8au@sssnet.com
- Date: Fri, 17 Dec 2004 23:54:55 -0500
- At 11:37 PM 12/17/04, Rick Williams wrote: Mark I'd sure question the module! Take the module out and gently take a pencil eraser to the contacts. Clean it off and re-insert it and try again. It shou
- /archives//html/TenTec/2004-12/msg00657.html (8,135 bytes)
This search system is powered by
Namazu