Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TowerTalk\]\s+Help\s+with\s+a\s+Yaesu\s+Rotator\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TowerTalk\]\s+Help\s+with\s+a\s+Yaesu\s+Rotator\s*$/: 3 ]

Total 3 documents matching your query.

1. [TowerTalk] Help with a Yaesu Rotator (score: 1): Author: Dick Allardyce via TowerTalk <towertalk@contesting.com>; Date: Tue, 5 Feb 2019 22:57:57 +0000 (UTC); I need a little help troubleshooting a Yaesu G800DXArotator. The rotator is about 5 years old and has been working fineso far. It has been used for turning astack of 6/2/432 yagis pretty light load; /archives//html/Towertalk/2019-02/msg00013.html (7,830 bytes)
2. Re: [TowerTalk] Help with a Yaesu Rotator (score: 1): Author: Grant Saviers <grants2@pacbell.net>; Date: Tue, 5 Feb 2019 16:27:32 -0800; I'm not sure that you have definitively isolated the problem to the rotator. The controller motor drive circuit has current regulators in it so they may be confusing the measurements. I think connect; /archives//html/Towertalk/2019-02/msg00014.html (9,366 bytes)
3. Re: [TowerTalk] Help with a Yaesu Rotator (score: 1): Author: Jack Brindle via TowerTalk <towertalk@contesting.com>; Date: Tue, 5 Feb 2019 20:58:10 -0800; Are you sure the wires to the rotor are OK? One of these (there are only two that drive the motor) building up resistance could cause the same symptoms. Check the connectors especially. 73! Jack, W6F; /archives//html/Towertalk/2019-02/msg00015.html (10,531 bytes)

Current List: 1 - 3
Page: [1]