Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TowerTalk\]\s+Installing\s+ham\s+V\s+in\s+25G\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TowerTalk\]\s+Installing\s+ham\s+V\s+in\s+25G\s*$/: 5 ]

Total 5 documents matching your query.

1. [TowerTalk] Installing ham V in 25G (score: 1): Author: K8RI <K8RI-on-TowerTalk@tm.net>; Date: Sat, 14 Apr 2012 16:39:41 -0400; I finished rebuilding the Ham V/IV some time ago and am ready to put the top section on the 50' 25G. What I've discovered is there is no way to fit the Ham V into the tower except lowering it down fr; /archives//html/Towertalk/2012-04/msg00227.html (6,723 bytes)
2. Re: [TowerTalk] Installing ham V in 25G (score: 1): Author: "Bill Parry" <bparry@rgv.rr.com>; Date: Sat, 14 Apr 2012 17:28:46 -0500; As far as I know, you either cut one of the side braces, or use a smaller rotator. I cut mine to install the Tailtwister 12 years ago to put it in my 120 feet tower with a 17 foot mast and it has mad; /archives//html/Towertalk/2012-04/msg00229.html (8,320 bytes)
3. Re: [TowerTalk] Installing ham V in 25G (score: 1): Author: W2RU - Bud Hippisley <W2RU@frontiernet.net>; Date: Sat, 14 Apr 2012 19:17:14 -0400; This is so "not a problem" by using either: a. Four standard 25G sections plus a 25AG4 top section; or b. Five standard 25G sections plus the 1-ft 4-in BAS25 Rohn bearing/accessory shelf section. In; /archives//html/Towertalk/2012-04/msg00231.html (9,183 bytes)
4. Re: [TowerTalk] Installing ham V in 25G (score: 1): Author: K8RI <K8RI-on-TowerTalk@tm.net>; Date: Sat, 14 Apr 2012 21:04:23 -0400; I'll have a Force 12 C19 XR about a foot above the top of the flat plate with a WARC 7 about 10' above it. With the 4.9 sq ft of wind area from the WARC 7 that would produce the leverage, or bending; /archives//html/Towertalk/2012-04/msg00235.html (9,356 bytes)
5. Re: [TowerTalk] Installing ham V in 25G (score: 1): Author: Steve Maki <lists@oakcom.org>; Date: Sun, 15 Apr 2012 10:32:08 -0400; Make a bolt-on brace to replace what you cut out - maybe a piece of angle and a couple of u-bolts? -Steve K8LX _______________________________________________ ________________________________________; /archives//html/Towertalk/2012-04/msg00240.html (7,946 bytes)

Current List: 1 - 5
Page: [1]