- 1. [TowerTalk] Joining masts/torquetube drive (score: 1)
- Author: tacookfam@exotrope.net (Thomas Cook)
- Date: Sun, 18 Jul 1999 12:48:05 -0400
- Gentlemen: I posted this on another reflector with a few interesting responses; thought I'd re-aim it directly at the tower gurus. I need to axially connect two pieces of 2"OD x 1/4" wall 6061-T6 (I
- /archives//html/Towertalk/1999-07/msg00304.html (8,179 bytes)
- 2. [TowerTalk] Joining masts/torquetube drive (score: 1)
- Author: K7LXC@aol.com (K7LXC@aol.com)
- Date: Sun, 18 Jul 1999 13:19:47 EDT
- Your aluminum mast of choice has about 35kpsi yield strength which is suitable for modest loads and windspeeds. For medium sized HF yagis or other mid-range mast torque stesses, the mast coupling har
- /archives//html/Towertalk/1999-07/msg00305.html (9,182 bytes)
- 3. [TowerTalk] Joining masts/torquetube drive (score: 1)
- Author: n1lo@hotmail.com (Mark L.)
- Date: Mon, 19 Jul 1999 13:27:29 GMT
- Hi Tom, For the sections inside the tower, I would install a thrust bearing above the first mast joint to take the bending stress off the joints. From here down to the rotor, then, you would have mos
- /archives//html/Towertalk/1999-07/msg00323.html (8,644 bytes)
This search system is powered by
Namazu