- 1. [TowerTalk] Stuck Rotator (score: 1)
- Author: "K8RI on TowerTalk" <K8RI-on-TowerTalk@tm.net>
- Date: Tue, 25 Jul 2006 16:23:08 -0400
- Several times I have mentioned the rotator sticking over the past few years. The previous winter (04) I discovered the TB-3 thrust bearing had worn to the point that the upper race was setting on the
- /archives//html/Towertalk/2006-07/msg00780.html (10,452 bytes)
- 2. Re: [TowerTalk] Stuck Rotator (score: 1)
- Author: "K8RI on TowerTalk" <K8RI-on-TowerTalk@tm.net>
- Date: Tue, 25 Jul 2006 21:37:48 -0400
- <snip> We split a bearing race and used it to support the steel inner part of the worm gear wheel. The shaft pressed out easily. It did take a bit more work to get the inner race for the top bearing
- /archives//html/Towertalk/2006-07/msg00784.html (9,457 bytes)
- 3. Re: [TowerTalk] Stuck Rotator (score: 1)
- Author: "K8RI on TowerTalk" <K8RI-on-TowerTalk@tm.net>
- Date: Wed, 26 Jul 2006 00:44:03 -0400
- I'm going to try and address both Rich and Jeff in this post and as this was sent off list which should have not made it past the filters and I don't know why, I'll do a bit more editing. I should po
- /archives//html/Towertalk/2006-07/msg00791.html (14,787 bytes)
- 4. Re: [TowerTalk] Stuck Rotator (score: 1)
- Author: "K8RI on TowerTalk" <K8RI-on-TowerTalk@tm.net>
- Date: Wed, 26 Jul 2006 19:16:22 -0400
- I hope you don't mind I chose to answer this on the reflector Jeff. The web page showing my work was updated around 7:00 PM tonight. This covers the disassembly of the output gear case on the old sty
- /archives//html/Towertalk/2006-07/msg00813.html (13,942 bytes)
This search system is powered by
Namazu