- 1. [TowerTalk] Thrust Bearings Again! (score: 1)
- Author: k3gt@pgh.net (Bob Thacker)
- Date: Fri, 12 Mar 1999 22:40:05 -0500
- Have an EZ-Way RBZ-66 crank up tower that has 2 bearings in the upper section. The top bearing is a bronze bushing on the mast and has about 3/32" clearance on a side. It requires a good quality grea
- /archives//html/Towertalk/1999-03/msg00213.html (7,263 bytes)
- 2. [TowerTalk] Thrust Bearings Again! (score: 1)
- Author: k3gt@pgh.net (Bob Thacker)
- Date: Sat, 13 Mar 1999 09:54:08 -0500
- That is what I probably will do Brad. Have a 4" to 2" plumbing reducer fitting to keep the dirt out as you mention. Relube it twice a year. Bob -- FAQ on WWW: http://www.contesting.com/towertalkfaq.h
- /archives//html/Towertalk/1999-03/msg00218.html (7,835 bytes)
- 3. [TowerTalk] Thrust Bearings Again! (score: 1)
- Author: k3gt@pgh.net (Bob Thacker)
- Date: Sat, 13 Mar 1999 10:42:46 -0500
- The top bronze bearing is still ok as is the inner ball bearing type. Was going to replace the bronze bearing but after consideration and a few suggestions, will leave it be. The inner EZ-Way tower s
- /archives//html/Towertalk/1999-03/msg00219.html (8,333 bytes)
This search system is powered by
Namazu