- 1. [TowerTalk] Yaesu G-1000DXA Rotator Measurements (score: 1)
- Author: Marinus Willemstijn <zs6maw@gmail.com>
- Date: Wed, 16 Jun 2010 16:53:17 +0200
- Good Day I wonder if someone can assist me. One of my connections in the shack broke and I did not take the colors of the pins so in short the problem is that I do not know which wire is which going
- /archives//html/Towertalk/2010-06/msg00146.html (7,141 bytes)
- 2. Re: [TowerTalk] Yaesu G-1000DXA Rotator Measurements (score: 1)
- Author: "Jim Brown" <jim@audiosystemsgroup.com>
- Date: Wed, 16 Jun 2010 08:42:03 -0700
- The schematic shows a six wire cable running between the rotor and the controller, but only five are used. Two wires are connected to the DC motor. They go to pins 4 and 5. Measured at the rotor, the
- /archives//html/Towertalk/2010-06/msg00148.html (8,125 bytes)
- 3. Re: [TowerTalk] Yaesu G-1000DXA Rotator Measurements (score: 1)
- Author: Marinus Willemstijn <zs6maw@gmail.com>
- Date: Wed, 16 Jun 2010 21:34:01 +0200
- Jim Thank You very much. I followed your instructions and got it back into working order again! 73 to all Marinus -- Marinus Willemstijn _______________________________________________ ______________
- /archives//html/Towertalk/2010-06/msg00156.html (9,181 bytes)
This search system is powered by
Namazu