Had a problem with PTT dropping out every now and then. Obviously, noticed it most while CQing. V10.55D is used but believe the problem has been around for a couple of prior versions. Using homemade
Mike, I have had this problem for some time also, using a Rigblaster for the interface. It has been reported many times but as far as I recall no one has come up with a solution or been able to ident
ORIGINAL MESSAGE: ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ I haven't seen it here, but it sounds possibly like RF getting into the PTT transistor. Does it happen with lower power? Bill, W6WR
Does your radio support RS-232 PTT? Give that a try. Dave Hachadorian, K6LL Yuma, AZ . _______________________________________________ WriteLog mailing list WriteLog@contesting.com http://lists.conte
Hi Bill, Power doesn't seem to matter. I run LP but have had it happen into a dummy load too. Don VE3XD ORIGINAL MESSAGE: ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ I haven't seen it here, but
ORIGINAL MESSAGE: ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Come to think of it, I have seen it here. I thought it had something to do with a macro. Here's the scenario: I am S&Ping. I find a
Mine mostly happens when I am running. It usually occurs just after the CQ message begins. Interestingly I can sometimes operate for an hour or more without it happening then it will occur several ti
Mike and others, At one time I thought the problem could be duplicated buy double hitting the programmed Function Keys. I have a mild case of tremors in my hands and once in awhile I would double hit
ORIGINAL MESSAGE: ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ One other possibility - just a guess - is the autosave feature may be interrupting things. Try turning autosave off next time. I be
In the RTTY Control panel Go to Option, setup, Misc tab. Set Sound loopback to OFF This fixed the problem for me. 73 Connie K5CM _______________________________________________ WriteLog mailing list
Well my Autosave is set to 10 so I don't think that is the problem. In fact you can often see the Autosave engage while transmitting without it interrupting anything. Connie K5CM has an interesting s
Mike, what are you using to generate PTT? I had this problem with Comm PTT enabled in WL, but havent had it since with serial port PTT. For the contest rigs at the camp, I built the 3 separate functi
I agree with Bill, but am not sure if I was clear enough. By Comm PTT I meant the setting COMPTT to Yes in writelog, which is a CAT signal to transmit or receive. By Serial I meant that I used a hard
For arguments sake, because someone will surely point it out as well, my previous message was assuming you're using MMTTY and not RttyRite alone. Of couse the All Mode PTT selection is the choice of