- 1. Cleaning aluminum (score: 1)
- Author: thompson@mindspring.com (David L. Thompson)
- Date: Wed, 12 Feb 1997 16:28:26 -0500
- I picked up a KT34A and plan on using the elements on my KT34XA on a rotating basis. Its not real clean and I must replace the green caps. I have steel wool, but remember someone told about using som
- /archives//html/Towertalk/1997-02/msg00272.html (7,190 bytes)
- 2. Cleaning aluminum (score: 1)
- Author: n4si@pobox.com (n4si@pobox.com)
- Date: Thu, 13 Feb 1997 00:39:55 +0000
- Don't use steel wool. Use Scotchbrite instead. Pads of it can be obtained at your local hardware store. Steel wool can leave very small traces of the steel in the aluminum which will eventually scor
- /archives//html/Towertalk/1997-02/msg00279.html (7,452 bytes)
- 3. Cleaning Aluminum (score: 1)
- Author: gjerning@flash.net (Arne Gjerning)
- Date: Wed, 12 Feb 1997 20:59:06 -0800
- Been reading posts for a monthor so. Dave, K4JRB asked how to clean aluminum. I hope he means tubing of antennas. The method I have used on may projects is inexpensive and does a great job. After cle
- /archives//html/Towertalk/1997-02/msg00286.html (8,227 bytes)
- 4. Cleaning aluminum (score: 1)
- Author: fisher@hp-and2.an.hp.com (Tony Brock-Fisher)
- Date: Thu, 13 Feb 1997 10:51:18 -0500
- For any kind of antenna rebuilding, I recommend getting some wire brushes similar to what plumbers use to clean copper pipe before sweating them. You can get inside and outside wire brush cleaners in
- /archives//html/Towertalk/1997-02/msg00297.html (7,707 bytes)
- 5. Cleaning Aluminum (score: 1)
- Author: ka8okh@som-uky.campus.mci.net (Rich Dailey, KA8OKH)
- Date: Thu, 13 Feb 1997 19:56:47 -0500
- I'll keep it short... Mother's wheel polish - try it. rich -- Rich Dailey - KA8OKH <ka8okh@som-uky.campus.mci.net> qrp-l #933 ars #223 If you push something hard enough, it will fall over - Fudd's la
- /archives//html/Towertalk/1997-02/msg00313.html (7,117 bytes)
This search system is powered by
Namazu