Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Rohn\s+Thrust\s+Bearings\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Rohn\s+Thrust\s+Bearings\s*$/: 6 ]

Total 6 documents matching your query.

1. Rohn Thrust Bearings (score: 1): Author: rfedor@magellan.cloudnet.com (Ralph Fedor); Date: Tue, 11 Jun 1996 22:03:50 -0500; I haven't used the TB-3 before but plan to in a new installation with a bearing-top 55G tower. Are these thrust bearings to be packed with grease before installation? Can they be? Are there any prefe; /archives//html/Towertalk/1996-06/msg00072.html (6,855 bytes)
2. Rohn Thrust Bearings (score: 1): Author: fisher@hp-and2.an.hp.com (Tony Brock-Fisher); Date: Wed, 12 Jun 1996 08:09:34 -0400; No, they don't come with much grease. Yes, they can be. Remove the screw; be careful not to loose the balls that fall out; squirt white lithium grease into the hole; replace the screw... -Tony, K1KP,; /archives//html/Towertalk/1996-06/msg00074.html (6,805 bytes)
3. Rohn Thrust Bearings (score: 1): Author: K7LXC@aol.com (K7LXC@aol.com); Date: Wed, 12 Jun 1996 10:23:42 -0400; bearing-top 55G >tower. Are these thrust bearings to be packed with greasebefore installation? Can >they be? Hi, Ralph -- The Rohn TB-3 is a non-lubricated thrust bearing. Since it only turns 1 RPM,; /archives//html/Towertalk/1996-06/msg00075.html (8,005 bytes)
4. Rohn Thrust Bearings (score: 1): Author: jholly@hposl62.cup.hp.com (Jim Hollenback); Date: Wed, 12 Jun 1996 08:22:00 -0700; this test, of course, works much better in the Seattle area than in the San Francisco area. Haven't had rain since May and don't expect any until at least Halloween. Dew doesn't happen much either. D; /archives//html/Towertalk/1996-06/msg00076.html (7,256 bytes)
5. Rohn Thrust Bearings (score: 1): Author: mraz@rockdal.aud.alcatel.com (Kris Mraz AA5UO); Date: Wed, 12 Jun 1996 10:21:49 -0500; I've talked with others who have used the Rohn bearings and they say that the bearings tear up pretty easily because they use aluminum races. After setting in one position for a long time the bearin; /archives//html/Towertalk/1996-06/msg00077.html (7,295 bytes)
6. Rohn Thrust Bearings (score: 1): Author: jallen@vhfcom.com (John D. Allen); Date: Thu, 13 Jun 1996 07:35:35 -0500; I have a TB3 that has been in use since 1980 on two towers, with 25 SQ of Wind Load. It still works fine. One Tower One, it was the second of two bearings, down about 2 feet from the flat top plate.; /archives//html/Towertalk/1996-06/msg00087.html (7,720 bytes)

Current List: 1 - 6
Page: [1]