This is a multi-part message in MIME format.
--------------528404A9C5B83BE7FC29DCCC
Content-Type: text/plain; charset=us-ascii
Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: 7bit
Content-Transfer-Encoding: 7bit
Hi all,
I'm still trying to put my Clipperton L AMp into service here. I had
it repaired(shorted tube and burned rectifier diodes), but now I can get
the radio to key the t/r relay in the Amp. I checked the cord and it's
OK, so when I short the center and shield on the cord, the Amp goes into
transmit. I jumpered the cord to the proper pins in the radio (pin2-tx
ground to center and pin 3-ground-to shield) and nothing happens. It
sems the radio just doesn't complete the circuit.
Yaesu tech support says the radio is supposed to take pin2 low to
ground. So, if that's true, how am I supposed to make this arrangement
work? Any suggestions?
Thanks in advance for your help
73s de Jonathan ko6xs
--------------528404A9C5B83BE7FC29DCCC
Content-Type: text/x-vcard; charset=us-ascii; name="vcard.vcf"
Content-Transfer-Encoding: 7bit
Content-Description: Card for Jonathan Kaplan
Content-Disposition: attachment; filename="vcard.vcf"
begin: vcard
fn: Jonathan Kaplan
n: Kaplan;Jonathan
org: JSK Enterprises, Inc.
adr: 6165 Zumirez Drive;;;Malibu;CA;90265;USA
email;internet: jonk@moonlink.net
title: President
tel;work: 310-457-1545
tel;fax: 310-589-1197
x-mozilla-cpt: ;0
x-mozilla-html: FALSE
end: vcard
--------------528404A9C5B83BE7FC29DCCC--
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|