About tuned input sections for amplifiers:
Everybody and their dog seems to have an affinity for the pi-net type of
tuned input.
Is there some practical reason not to use a T-net?
I was thinking of using molded chokes that are easily found from Digikey,
Mouser, etc., for the inductors...typical values in the 1.0-7.5uH range are
cheap, are rated for 500-600mAdc, and have RF-tested Q's of 35-40. Which
isn't much, but is more than sufficient for a network with a loaded Q of
between 2 and 5.
Or are these molded chokes weak in some aspect? Should I "roll my own" on
powdered iron toroids?
Looking forward to any comments/observations.
Thanks!
------------
Scott Townley
nx7u@primenet.com
------------
Collector of:
Stoddard Aircraft EMI/RFI receivers and accessories
Big Parts for that Big Linear Amp
70's era RF test equipment HP/GR/Tek
Radio-related technical reference material 1940+
...anything else that will keep me off the streets at night
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|