reading eimacs Fault Protection it suggest this resistor for tube of
1500 watts or less, and a more complicated system for larger thoriated
tungsten tubes,
is using B+ current limiting resistors in 9k 3amps power supplies
still appropriate, this would require very large wattage resistors to
meet eimacs 50 joule and less energy dissapation, i have tried the #30
wire short test with resistors, it always leads to destruction of the
wire! 9kv at 3amps is a huge energy load to disipate. Any opinions
would be appreciated.
Sorry for all these simple questions, i am not a broadcast engineer,
but trying to learn as much as i can.
Igor
_________________________________________________________
DO YOU YAHOO!?
Get your free @yahoo.com address at http://mail.yahoo.com
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|