I've sometimes found inexpensive aluminum cookie sheets at the grocery
store.
How's your scrounging? I've sometimes found pieces of techno-junk that had
large pieces of sheet aluminum attached as shielding. Alternatively, can
you use steel? I know it won't match, it rusts, it can be harder to
fabricate,
but it works OK for shielding. And you should be able to get roof flashing
at the corner Ace hardware store in the right width.
Jim
-----Original Message-----
From: John / NS1Z [mailto:ns1z@agate.net]
Sent: Wednesday, January 27, 1999 1:25 PM
To: amps@contesting.com
Subject: [AMPS] Aluminum sheet
Looking for sources of aluminum sheet for the cabinet of my HB 6 meter amp.
Aubuchon and Ace hardware stores (in my area) do not have anything. Any
suggestions on a source? Largest piece would be 17X12"
I am sorry I have nothing to add on license requirements which hasn't been
better said by others...
John Wilcox NS1Z
FN44rn
ns1z@agate.net
fon: 207-364-2246
871 Route 120
Rumford, ME 04276-3836
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|