In message <36C68DB0.7BA49915@dtgnet.com>, W7XU Arliss <w7xu@dtgnet.com>
writes
>
>Hi,
>
>I think the efficiency of my homebrew 6m 8877 amp is
>lower than it should be (currently about 50 %), and am
>looking for some suggestions on how to improve the
>situation.
>
>The amp runs about 2800 V key down at 1 amp, with 50 mA
>of grid current, into a 50 ohm load. Idling current
>(set with a 12V Zener) is about 75 mA. The plate
>circuit is a Pi-L network patterned after Lauren Libby's
>(W0LD) HR article from July 1986, using a vacuum variable
>tuning capacitor, 3/16" copper tubing for the coil, and
>a 250 pF air variable for the loading coil.
>
>I've tried varying the coil size somewhat but that hasn't
>made any difference. I also tried increasing the plate
>voltage to 3500 V, which reduced the drive requirement,
>but didn't make a significant difference in the amp's
>efficiency. The coil is about 1.5" away from the cabinet
>lid.
>
>Other suggestions?
>
>Thanks & 73, Arliss W7XU
How are you measuring the output power?
Steve
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|