Amps
[Top] [All Lists]

[AMPS] Two EHT Transformers

To: <amps@contesting.com>
Subject: [AMPS] Two EHT Transformers
From: mike@g0mjw.freeserve.co.uk" <mike@g0mjw.freeserve.co.uk (M.J.Willis)
Date: Mon, 21 Jun 1999 08:26:20 +0100

I have just obtined a nice EHT transformer 1800-0-1800 V at 450ma DC. 50Hz. 
This will give via a full wave rectifier circuit 2.5kV. Not sure of the 
current but probably quite a bit, it weighs 20kg and has 130ohms secondary 
resistance through the entire winding, 65 ohms in each half. To work out 
the amateur power output is non-trivial, but I would hope it is around 2kVA 
for 50% duty.

I need 3.5kV - not 2.5kV. Is it sensible to add another transformer in 
series? Normally one grounds the centre tap, but I have seen the lower 
voltage versions of this transformer e.g. 900-0-900 1A used with a bridge 
to give 2.5kV, implying the centre tap can sit at half EHT. The transformer 
is vacuum impregnated with varnish.

Effectively, I want to series a 1kV PSU and a 2.5KV PSU - will it work 
without drama?

73 Mike


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>