I am forwarding this for Joe.
-----Original Message-----
From: JSheinb785@aol.com <mailto:JSheinb785@aol.com>
[mailto:JSheinb785@aol.com] <mailto:[mailto:JSheinb785@aol.com]>
Sent: Sunday, October 03, 1999 9:02 PM
To: kenwood@qth.net <mailto:kenwood@qth.net>
Subject: [Kenwood] TL-922 problem
Recently I had to replace the power switch on the amplifier and before I put
the panel back in I wanted to see if it worked properly, which it did.
However, in replacing the switch panel I accidentally shorted the 120
terminals on the switch to the chassis & blew both fuses. I replaced the
fuses (pulled the plug to the wall first!), tried to turn on the amp, but
nothing happened. I checked the voltage at the power plug on the amp & it
read 220Volts.
Anyone have any ideas on what to look for?
Thanks and 73,
Joe, WD5FHG
-
Your Moderator is: Larry Wilson KE1HZ
EMail: owner-kenwood@qth.net <mailto:owner-kenwood@qth.net>
-----
Submissions: kenwood@qth.net <mailto:kenwood@qth.net>
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|